Loading ...
Loading ...
Loading ...
9
C. Setup
CAUTION
It is especially important that the ice bin is leveled in both left-to-right and front-
to-rear directions. If it is not level, the result could be the production of smaller
orirregularshapedcubesorofoverowintotheicebin.Seethe"LOCATION"
instructions on the icemaker.
1. Unpacking the Ice Bin and Attaching the Snout Assembly
1) Unpack the ice bin, and remove all shipping cartons, tape(s) and packing. Remove the
two bolts holding the ice bin to the pallet. Attach four (4) adjustable legs [adjustable
withinmax.6-13/32"(188mm)tomin.6"(152mm)]tothebottomoftheicebin.Be
careful not to damage the panels when installing the ice bin.
2) Position the ice bin in a selected permanent site.
3) Remove the snout assembly from the box.
4) Remove any packing from the snout assembly.
5) Apply the gasket (included) to the perimeter of the snout assembly where it mates with
the ice bin.
6) Position the snout assembly onto the bin by first placing the bottom of the assembly into
the lower hole on the bin's front panel and then rotating the top towards the bin.
7) Install the four screws (included) along the top of the snout assembly.
8) Clean and wipe the interior of the bin and snout assembly with a clean cloth.
Fig. 1
Snout Assembly
Loading ...
Loading ...
Loading ...