Loading ...
Loading ...
Loading ...
INSTALLATION
Check the appliance is electrically safe and gas sound when you have nished.
26
ArtNo.280-0030 - Fixing Flue Grill
ArtNo.280-0031 - Flue Extension Fixing
Position the range close to its nal position, leaving just
enough space to get behind it (Fig. 9.9).
IMPORTANT: Remove all tape and packaging. Make sure
the burner heads are properly seated and level. Take the
accessory pack out of the oven. Check to be sure that no
range parts have come loose during shipping.
Installing the flue grille
The ue grille is packed separately (Fig. 9.10).
The larger of the holes along the sides are for screwdriver
access and should face to the rear. Use the screws and nuts
supplied to hold the grille in place (Fig. 9.11).
Clip the exible extension of the oven ue to the ue grille
using the clip provided inside the ue grille (Fig. 9.12).
Leveling
It is recommended that you use a spirit level on a shelf in the
oven to check the level.
Place the range in its intended position, taking care not to
twist it within the gap between the kitchen units as damage
may occur to the range or the units.
The front feet and rear rollers can be adjusted to level the
range. To adjust the height of the rear of the range turn the
adjusting nuts at the front bottom corners of the range.
Anti-tip device
NOTE: The range must be set to the correct height and
leveled before the anti-tip bracket is installed.
Fitting the anti-tip device
A range using a exible gas connector must be secured with
a suitable anti-tip device.
A suitable anti-tip device is supplied and shown in Fig. 9.13.
When tting the anti-tip bracket (Fig. 9.14 and Fig. 9.15),
adjust the bracket to give the smallest practicable clearance
between the bracket and the engagement slot in the rear of
the range.
Fit the bracket so that it engages as far as possible over the
chassis of the range.
DO NOT operate the range before the appliance is
in its installed position and the anti-tip devices are
engaged.
If the appliance is moved ensure that the anti-tip
devices are re-engaged and the range has been
returned to its original installed position.
DO NOT step, lean or swing on the range doors
or drawer as this could tip the range and result in
serious injury or death.
Fig. 9.9
Fig. 9.10
Fig. 9.11
Alternative positions
for anti-tip device
ArtNo.070-0014 - Stability bracket - Wall fitting
Cooker
Stability bracket
Floor
3 mm min
Typical oor mounting
0
1
/
8
" (3 mm) min
Fig. 9.12
Fig. 9.13
Fig. 9.14
Alternative positions for
anti-tip device
Anti-tip bracket
Typical oor mounting
Range
Floor
Loading ...
Loading ...
Loading ...