Loading ...
Loading ...
Loading ...
6
Installing and Removing Blades
Spindle lock button
To remove, turn
counterclockwise
1. Remove battery pack.
2. Remove the chip container (see"Removing and
Installing Chip Container").
3. Place the saw on a at surface with the blade fac-
ing upwards. To remove the bolt from the spindle,
push in the spindle lock button. While holding in the
spindle lock button, use the wrench provided with
the tool to turn the bolt counterclockwise. Remove
the bolt and outer ange.
4. Slide the lower guard lever up to raise the lower
guard. Remove the blade from the spindle. Always
clean the spindle, upper guard and lower guard to
remove any dirt and dust.
NOTE: Do not remove inner ange or washer.
Larger diameter of inner ange should face the
blade.
5. To install a blade, place the
Arrow
blade on the spindle with
the teeth pointing in the
same direction as the ar-
row on the lower guard.
Release the lower guard lever.
6. Place the blade ange on the spindle and hand
tighten the bolt.
7. While holding in the spindle lock button, use the
wrench to turn the bolt clockwise and tighten.
8. Replace the chip container (see "Removing and
Installing Chip Container").
Adjusting Depth
1. Remove battery pack.
2. To adjust the depth of the cut, hold the saw by the
handle and loosen the depth adjusting lever by
pulling it up away from the shoe.
3. When restarting a saw in the workpiece, center
the saw blade in the kerf and check that saw teeth
are not engaged into the material. If saw blade
is binding, it may walk up or kickback from the
workpiece as the saw is restarted.
1/4"
4. Push down the depth adjusting lever to secure
the shoe position.
Loading ...
Loading ...
Loading ...