Loading ...
Loading ...
Loading ...
9
Servicing the System
WARNING
Unintentional sparking could cause fire or
electric shock resulting in death or serious injury.
When adjusting or making repairs to your generator
• Disconnect the spark plug wire from the spark plug and place
the wire where it cannot contact spark plug.
WHEN TESTING FOR ENGINE SPARK
• Use approved spark plug tester.
• DO NOT check for spark with spark plug removed.
Before performing any generator maintenance, always
perform the following steps:
1. Set generator circuit breaker to its OFF position.
2. Press controller OFF button.
3. Remove 15 Amp fuse from controller.
4. Utility voltage is present at generator controller.
Disconnect power before servicing controller by
removing the fuses from the transfer switch.
After all servicing has been completed, reinstall fuses
in transfer switch, replace 15 Amp fuse in controller, set
circuit breaker ON and reset exercise timer. See Setting the
Exercise Timer.
Service Code Detection System
During a utility power failure, the generator may have to
run for long periods of time with no operator present. The
generator is equipped with sensors that automatically shut
down the generator in the event of potentially damaging
conditions, such as low oil pressure, high temperature, or
over speed.
The Service Code Detection System installed in the
standby generator monitors for potential operation failures
to protect the unit. The operation failure will be shown in the
display window of the system controller. The service code
descriptions and explanations are listed below.
• Low Battery Voltage
• Low Oil Pressure
• Low Coolant Level
• Under Voltage
• Over Voltage
• Engine Does Not Start
• Low Frequency
• Engine Overspeed
• Service Engine
• High Coolant Temperature Warning
• High Coolant Temperature
• Transfer Switch Fault
• No Wireless Communication (optional)
• Battery Charge Circuit
Low Battery Voltage
This service code is indicated by LOW BATTERY
VOLTAGE in the display. This condition occurs if the battery
voltage drops below the preset value.
Remove the 15 Amp fuse and disconnect the battery from
the generator. Test the battery voltage. If voltage meets
specifications, contact your installer or an authorized dealer
to have the battery serviced or replaced.
Reinstall the battery, and then reset the service code
detection system, as described at the end of this section.
Low Oil Pressure
This service code is indicated by LOW OIL PRESSURE in
the display. Should oil pressure drop below approximately
50 psi, the engine will shut down. To resolve this condition,
add the recommended oil to the FULL mark on the dipstick.
If the condition continues, the engine will start and then shut
down again. To resolve the condition, contact your installer
or an authorized dealer.
Low Coolant Level
This service code is indicated by LOW COOLANT LEVEL
in the display. If the coolant drops below a pre-set level,
the engine will shut down. To resolve the condition, let the
engine cool down and add coolant to the cooling system.
If the condition continues, contact your installer or an
authorized dealer.
Under Voltage
This service code is indicated by UNDER VOLTAGE in
the display. This condition is caused by a restriction in the
fuel flow, the electronic governing system not functioning
properly, a broken or disconnected sensing lead, a failed
alternator winding, the control board circuit breaker Open,
or the generator being overloaded. To resolve the condition,
contact your installer or an authorized dealer.
Over Voltage
This service code is indicated by OVER VOLTAGE in
the display. This feature protects devices connected to
the transfer switch by shutting the generator down if the
generator output voltage increases above the pre-set limit.
This condition is most likely caused by a failed voltage
regulator, alternator excitation circuit, or a load imbalance.
To resolve the condition, contact your installer or an
authorized dealer.
Not for
Reproduction
Loading ...
Loading ...
Loading ...