Troy-Bilt 24B-070J766 Log Splitter Model

OPERATOR’S MANUAL - Page 19

For 24B-070J766.

PDF File Manual, 28 pages, Read Online | Download pdf file

24B-070J766 photo
Loading ...
Loading ...
Loading ...
Troubleshooting
8
19
Problem Cause Remedy
Engine Fails to start Throttle lever not in correct starting position. 1.
Spark plug wire disconnected.2.
Choke not in CHOKE position (if equipped).3.
Fuel tank empty or stale fuel.4.
Engine not primed (if equipped).5.
Faulty spark plug.6.
Engine flooded.7.
Safety switch not depressed. 8.
Safety switch wire is not connected to engine 9.
or not properly grounded.
Move throttle lever to FAST or START 1.
position.
Connect wire to spark plug.2.
Move choke lever to CHOKE position.3.
Fill tank with clean, fresh gasoline.4.
Prime engine as instructed in Engine Manual.5.
Clean, adjust gap, or replace.6.
Safety switch must be depressed by the front 7.
tab on the bag handle when securing the
bag.
Connect safety switch wire to engine 8.
connector and ground to mounting bracket.
Wait a few minutes to restart, but do not 9.
prime.
Engine runs erratic Spark plug boot loose.1.
Unit running on CHOKE (if equipped).2.
Blocked fuel line or stale fuel. 3.
Low engine RPM.4.
Water or dirt in fuel system.5.
Dirty air cleaner.6.
Carburetor out of adjustment.7.
Connect and tighten spark plug boot.1.
Move choke lever to OFF position.2.
Clean fuel line; fill tank with clean, fresh 3.
gasoline.
Always run engine at full throttle.4.
Drain fuel tank. Refill with fresh fuel.5.
Refer to engine manual.6.
See authorized service dealer.7.
Engine overheats Engine oil level low.1.
Dirty air cleaner.2.
Carburetor not adjusted properly.3.
Fill crankcase with proper oil.1.
Refer to engine manual.2.
See authorized service dealer.3.
Continued on next page
Loading ...
Loading ...
Loading ...