Loading ...
Loading ...
Loading ...
11INSTALLATION
ENGLISH
Unpacking and Removing
Shipping Material
Remove all shipping materials from the washer for
proper operation and inspect it for shipping
damage.
CAUTION
• Failure to remove shipping materials can cause
excessive noise and vibration.
Unpacking Shipping Material
1 Lift the washer off of the foam base.
• After removing the carton and shipping
material, lift the washer off the foam base.
• Make sure the plastic tub support
a comes
off with the base and is not stuck to the
bottom of the washer.
• If you must lay the washer down to remove
the carton base
b, always protect the side
of the washer and lay it carefully on its side.
Do not lay the washer on its front or back.
2 Remove the foam tub insert.
• To prevent damage, do not remove the
foam insert
c from the tub until the washer
is in the final location.
NOTE
•Once removed, save the foam insert for future
use. If the washer needs to be moved, the foam
insert will help prevent damage during
transportation.
3 Unfasten the power cord.
• Unfasten the power cord from the back of
the washer.
Connecting the Water Inlet
Hoses
To avoid the risk of costly water damage, purchase
and install new inlet hoses when installing the
washer.
WARNING
• Do not overtighten the hoses or cross-thread the
hose fittings. Overtightening or cross-threading
can damage the valves or couplings, resulting in
leaking and property damage.
• Do not reuse old hoses. Use only new hoses
when installing the washer. Old hoses could leak
or burst causing flooding and property damage.
Contact an LG Customer Information Center for
assistance in buying hoses.
NOTE
• Periodically check the hoses for cracks, leaks,
and wear, and replace the hoses every five years.
• Do not stretch the water hoses intentionally, and
make sure that they are not pinched, crushed or
kinked by other objects.
• Water supply pressure must be between 20 psi
and 120 psi (138 - 827 kPa). If the water supply
pressure is more than 120 psi, a pressure
reducing valve must be installed.
• Your hot water heater should be set to deliver
water at 120 - 135°F (48 - 57°C) to allow the
washer to properly control wash temperatures.
Loading ...
Loading ...
Loading ...