Loading ...
Loading ...
Loading ...
RE3
UHF Wireless Quick setup | en 19
Electro
-Voice Installation manual 2021.06 | 03 | F.01U.362.808
6 Quick setup
6.1 Preparing the receiver
a. Remove the receiver, packaged power supply kit and two antennas from the product
carton.
b. Place the receiver either on a stable flat surface or in a 19” rack using the rack kit
supplied.
c. Locate the power supply and attach the supplied AC wall outlet clip which is
appropriate for your country’s mains power by sliding it into the power supply head,
and plug the DC power lead end of the cable into the receiver DC input jack.
d. Locate, unwrap, and attach the two supplied receiver antennas by inserting them
onto the receiver’s BNC antenna jacks and locking them into place by applying a
right-hand twist. Take special care to ensure the receiver antennas are exposed to
open air, not touching any items that would ground them, and oriented 90 degrees to
one another and positioned at 45 degrees relative to the floor.
e. Turn on the receiver by pressing the power button.
f. Ensure the transmitter for this set is turned off.
g. Press the scan button and follow the scanning instructions described in Scanning
for open channels, page 24.
h. After the scan is complete, select the group and channel from the results list which
best matches your system needs.
i. Follow the scanning instructions in Scanning for open channels, page 24 to return
the receiver’s display to the home screen.
j. Leave the receiver on until the desired mating transmitter has been prepared and
synced.
6.2 Preparing the transmitter
a. Remove the transmitter, batteries, and input device (if supplied) from the product
carton.
b. Insert the batteries into the transmitter paying close attention to the battery polarity
(+ and -) and matching those polarities to the + and – poles of the battery
compartment battery clips.
c. Connect the transmitter’s input device to the transmitter (a bodypack set will contain
either a lavalier microphone, headworn microphone, or instrument cable – a
handheld set will contain a thread-on microphone head.
d. Turn on the transmitter by pressing the power button.
6.3 Sync the transmitter to the receiver
a. Locate the transmitter’s sync port and the receiver’s sync emitter which are both
identified with the symbol.
b. Maintaining direct line of sight and a separation distance of two to twelve inches
between the transmitter and receiver ports.
Loading ...
Loading ...
Loading ...