Loading ...
Loading ...
Loading ...
12 49-1000603 Rev 0
WATER FILTER CARTRIDGE
The water filter cartridge is located in the refrigerator
interior on the left side wall, near the top.
Select models use radio frequency identification (RFID) to
detect leaks and monitor filter status. The RFID technology
is certified by the FCC.
When to Replace the Filter Cartridge
The filter cartridge should be replaced every six months
or earlier if 170 gallons (643.52 liters) of water has been
dispensed or the flow of water to the dispenser or icemaker
decreases.
Touch Screen Models: A filter status message will appear
on the screen when the water filter needs to be replaced.
The filter status will automatically update when the filter is
replaced.
Non-touch Screen Models: A filter indicator light will
illuminate on the screen when the water filter needs to be
replaced.
Removing the Filter Cartridge
DO NOT TWIST CARTRIDGE! Twisting may damage
refrigerator or filter.
1. Remove the old cartridge by opening the filter door and
pulling on the bottom of the cartridge to allow it to swing
outward.
2.
When the cartridge can no
longer swing, gently pull to
unseat from the cartridge
holder. A small amount of
water may drip out.
DO NOT TWIST CARTRIDGE!
Installing the Filter Cartridge
1. Center the cartridge with cartridge holder with the word
FRONT facing outward. Push the cartridge inward
until it is fully seated. FRONT should be centered with
the cartridge holder for proper installation. The RED
indicators should not be visible.
2. While continuing to ensure cartridge is fully seated in the
holder, gently swing the filter inward until it is in position. If
filter will not swing easily, check to ensure filter is properly
aligned and fully seated within the cartridge holder.
3.
For dispenser models – Run two gallons (7.75 Liters) of
water through the cold water dispenser (about 5 minutes)
to remove air from the system. A newly installed filter
cartridge will cause water to spurt from the dispenser. Use
a large pitcher or sports bottle to catch the water spray.
NOTE: It is normal for water to appear discolored during
the initial system flush. Water color will return to normal
after the first few minutes of dispensing.
For icemaker-only models – Discard the first bin of ice
to allow air to purge from the system. A newly installed
filter cartridge will cause water to spurt into the icemaker
body, which could lead to ice droplets around the
icemaker area. NOTE: It is normal for these droplets
and initial ice production to appear discolored during the
initial system flush. Ice color will return to normal after
the first bin of ice production.
DO NOT use the hot water dispenser or Autofill function
until all air is removed from the system.
4. Reset Filter status message (non-touch screen models).
Filter Bypass Plug
To reduce the risk of property damage due to water
leakage, you MUST use the filter bypass plug when a
replacement filter cartridge is not available. Some models
do not come equipped with the filter bypass plug. To obtain
a free bypass plug, visit us on-line at geappliances.com/
service. In Canada, visit
geappliances.ca/service. The dispenser and icemaker
will not operate without either the filter or the bypass plug
installed. The bypass plug is installed in the same way as a
filter cartridge.
RPWFE WATER FILTER
WARNING
To reduce the risk associated with
choking, do not allow children under 3 years of age to have
access to small parts during the installation of this product.
AVERTISSEMENT
Pour réduire le risque
d’étouffement pendant l’installation de ce produit, ne pas
laisser les petites pièces à la portée des enfants âgés de
moins de 3 ans.
ADVERTENCIA
A fin de reducir el riesgo
asociado con asfixia, no permita que los niños menores
de 3 años tengan acceso a las partes pequeñas durante
la instalación de este producto.
The disposable filter cartridge should be replaced every
6 months at the rated capacity, or sooner if a noticeable
reduction in flow rate occurs.
For the maximum benefit of your filtration system, GE
Appliances, a Haier company, recommends the use of
GE Appliances-branded filters only. Using GE Appliances-
branded filters in GE Appliances refrigerators provides optimal
performance and reliability. Our filters meet rigorous industry
NSF standards for safety and quality that are important for
products that are filtering your water. There is no assurance
that brands other than GE Appliances filters meet our
standards for quality, performance and reliability.
If you have questions, or to order additional filter
cartridges, visit gewaterfilters.com. In Canada, visit
GEAappliances.ca/service or consult the yellow pages for
the nearest Camco Service Center.
FCCID: ZKJ-EBX1532P001
ICID: 10229A-EBX1532P001
“This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including
interference that may cause undesired operation.”
“This device complies with Industry Canada licence-exempt
RSS standard(s). Operation is subject to the following two
conditions: (1) this device may not cause interference, and (2)
this device must accept any interference, including interference
that may cause undesired operation of the device.”
1
2
FRONT
FRONT
3
4
Red indicators
should not be
visible
Loading ...
Loading ...
Loading ...