Loading ...
Loading ...
Loading ...
User Manual of Network Camera
90
Steps:
1. Click Rule Tab to enter the rule configuration interface.
2. Check the checkbox of Rule to enable rules of behavior analysis.
3. Select the rule type as None, Line Crossing, Intrusion, Region Entrance, and
Region Exiting.
Notes:
● If you select the rule type as None, the rule option is invalid, and no
behavior analysis can be configured.
● Up to 8 rules are configurable.
4. Select Filter type. Pixels and Actual Size are selectable.
Pixels: Draw the area of maximum size and minimum size for each rule. After
the area is drawn, there is a background algorithm converts the area size to
the pixel.
Actual Size: Configure the actual size for each rule. Input the length and
width of the max. size, and input the width of max. size and min. size.
Note:
Make sure the camera calibration is configured if actual size is selected.
5. Draw areas. If the intrusion, region entrance or region existing is selected,
you have to draw the configure area by left click end-points in the live view
window, and right click to finish the area drawing. If line crossing is selected,
you have to draw a line, and select the crossing direction, which is
bidirectional, A-to-B, or B-to-A.
Note:
There is no way to draw the area/line, or enable rules if live view is stopped.
6. Click Save to save the settings.
7. Click Arming Schedule tab, click Edit to set the schedule time for each rule,
and click Save to save the settings.
8. Click Alarm Linkage tab, check the checkbox of corresponding linkage
method for each rule, and click Save to save the settings.
Advanced Configuration
● Parameter
Configure the following parameters to detail the configuration.
Loading ...
Loading ...
Loading ...