Loading ...
Loading ...
Loading ...
36 TROUBLESHOOTING
Rinse+Spin LED
Blinks
DRAIN FEATURE
Special drain feature
• If the washer is paused during a cycle for more than 4 minutes, the cycle will be canceled
and any water remaining in the tub will be drained.
• This is not an error code. It indicates that the drain function is operating.
Door Lock and
Control Lock LEDs
Blink
LID ERROR
Lid is not closed properly.
• Close the lid properly.
• If the lid is closed and this error message is still displayed, call for service.
Door Lock LED Blinks
LID LOCK ERROR
Lid is not locked properly.
• Make sure that the lid is closed properly and press the Start/Pause button. You can hear
the locking sound to lock the lid in the beginning of the cycle. The washer will not operate
unless the lid is locked.
• Make sure that nothing is caught under the lid, including shipping material or clothing.
• Make sure that the latch mechanism is fully retracted.Make sure that the latch mechanism
is fully retracted.
• If the lid is closed and this error message is still displayed, call for service.
Water Plus and Cold
LEDs Blink
FOREIGN OBJECT
ERROR
Foreign objects such as coins, pins, clips, etc., are caught between the pulsator and the
inner tub.
• Turn the washer off then on again. Select the Spin Only cycle to drain and spin the load.
• When the Spin Only cycle is completed, empty the tub and find and remove any objects
caught in the pulsator.
• Always check pockets, etc., before washing to prevent error codes or damage to the
washer or clothing.
Tub Clean LED Blinks
TUB CLEAN ALARM
It is time to run the Tub Clean cycle.
• This is not an error code. It indicates that the Tub Clean cycle is running or needs to be run
to clean the washer tub.
• Not applicable for all models.
Rinse+Spin and
Warm LEDs Blink
TEMPERATURE
SENSOR ERROR
Control error
• Unplug the washer and wait 60 minutes. Reconnect power and try again.
• If the error code is still displayed, call for service.
Rinse+Spin and Cold
LEDs Blink
OVERFLOW ERROR
Water level is too high due to a faulty water valve.
• Close the water faucets, unplug the washer, and call for service.
Hot LED Blinks
PRESSURE SENSOR
ERROR
The water level sensor is not working correctly.
• Close the water faucets, unplug the washer, and call for service.
Heavy Soil and Cold
LEDs Blink
MOTOR LOCKED
ERROR
A motor error has occurred.
• Allow the washer to stand for 30 minutes and then restart the cycle.
• If the error code is still displayed, call for service.
Heavy Soil LED Blinks
CLUTCH ERROR
Clutch error
• Mechanical failure
• Unplug the washer and call for service.
Heavy Soil and Warm
LEDs Blink
SUPPLY VOLTAGE
ERROR
Supply voltage is not correct.
• Please call LG service center. You can find your local LG service center phone number
onback cover page.
Problem Possible Cause & Solution
Loading ...
Loading ...
Loading ...