Loading ...
Loading ...
Loading ...
VIVOTEK
8 - User's Manual
1
2
3
4
6
5
8
7
10
LAN/PoE
100~240V
AC
ON
OFF
9
GE LAN GE LAN
802.3at
24V 3.5A
PoE
injector
Power Consumption
Due to its onboard heater for operation in the low temperature environments, care
should be taken when selecting the power source for the camera. Listed below are the
requirements for powering the camera:
Use conditions Power consumption & Input
≥-20ºC PoE+ - 21.95W (PoE Plus mid-span or switch, 42V/0.57A~0.42A)
≥-40ºC AC 24V input, 1.5A/pf:0.619, - 21.1W
In warmer areas that do not need a heater, a PoE+ switch can drive the camera. In areas
where temperature can drop below -20ºC, an AC 24V power adaptor is required.
• Many copper coated aluminum (CCA) and other non-standard conductors cabling
products are masqueraded as CAT5E or CAT6 cables. Please avoid using these CCA
products especially when cascading PoE cameras. It is a must to use Ethernet cables
compliant with the 3P/ETL standard.
• The camera is able to operate in low temperature environments. However, when
starting these cameras in a very low temperature condition, e.g., -40ºC, the embedded
heater may take half an hour to warm up the camera. When the temperature within the
canister reaches -10ºC, the camera automatically starts.
IMPORTANT:
Hardware Reset
The reset button is used to reset the system or restore the factory default settings.
Sometimes resetting the system can return the camera to normal operation. If the system
problems remain after reset, restore the factory settings and install again.
Reset: Press the recessed reset button. Wait for the Network Camera to reboot.
Restore: Press and hold the reset button until the status LED rapidly blinks. Note that all
settings will be restored to factory default. Upon successful restore, the status LED will
blink green and red during normal operation.
SD/SDHC/SDXC Card Capacity
This network camera is compliant with SD/SDHC/SDXC 16GB / 8GB / 32GB / 64GB and
other preceding standard SD cards.
Loading ...
Loading ...
Loading ...