Loading ...
Loading ...
Loading ...
Cutting Deck Removal
To remove the cutting deck, proceed as follows:
position and engage the parking brake.
2. Lower the deck by moving the deck lift lever into the
bottom notch on the right fender.
3.
Remove the belt guard and belt as follows Refer to Figure
a. Remove the hex screws.
b. Pull the belt keeper rod to the right and down to
remove.
c.
Belt Keeper
Rod
Figure 7-1
NOTE: If there is too much tension on the belt for it to be
a ⁄ drive ratchet wrench (set to loosen) into the square
hole found in the left-hand deck idler bracket and pivot it
See Figure 7-2.
WARNING! Avoid pinching injuries. Never place
your fingers on the idler spring or between the belt
and a pulley while removing the belt.
Belt Guard
Figure 7-2
5. Looking at the cutting deck from the left side of the tractor,
locate the deck support pin on the rear left side of the
deck. Refer to Figure 7-3.
Pull the deck support pin outward to release the deck from
the deck lift arm. See Figure 7-3.
7.
8. Move the deck lift lever into the top notch to raise the deck
lift arms up and out of the way.
Deck Support Pin
Figure 7-3
Se rvice
7
25
Loading ...
Loading ...
Loading ...