Loading ...
Loading ...
Loading ...
8 9
CLEANING (CONT'D)
If scale becomes difcult to remove with brush:
1. Fill the base with a mixture of 1 tsp. white vinegar and 1 tsp.
water.
2. Let the solution stand for 5 minutes.
3. While the vinegar is in the base, clean all of the interior surfaces
with a soft cloth or brush to help remove scale.
4. Check for buildup in the mist nozzle and mist tube. Clean as
needed.
5. Rinse the base thoroughly with water to remove scale and all of
the vinegar solution.
6. If minerals in your water are producing a white dust, you may
use a decalcication cartridge or humidier cleaner cartridge to
keep the tank clean.
END OF SEASON STORAGE
• Follow the General Cleaning and Descaling instructions on
pages 8-9 to get your humidier ready for storage at the end of
the season.
• Dry the humidier completely before storing. DO NOT store with
water inside the base or water tank.
• Pack the unit in its original box and store in a cool, dry location.
NOTE: IF YOU EXPERIENCE A PROBLEM WITH THIS PRODUCT,
DO NOT ATTEMPT TO OPEN THE MOTOR HOUSING BY
YOURSELF. DOING SO MAY VOID YOUR WARRANTY AND
CAUSE DAMAGE TO THE HUMIDIFIER OR PERSONAL INJURY.
TROUBLESHOOTING
If you are having problems with your humidier, see if one of the
solutions below resolves the problem before contacting Pure
Enrichment.
Problem Solution
Water vapor and
humidity are not being
produced.
Power plug: Unplug and then try again.
Power Failure: When power returns, try again.
Tank Installation: Ensure tank is attached
properly.
Dirty ultrasonic disk: Clean disk (see page 9)
Air blows but water
vapor is not produced.
Excessive Water: Pour out extra water.
Residue inside tank: Wash tank and try again.
Dirty ultrasonic disk: Clean disk (see page 9)
If you use hard water, replace with softer water.
Humidity level is low. Dirty ultrasonic disk: Clean disk (see page 9)
Water in unit is too cold: Replace with cool
water.
The humidity has a bad
smell.
Poor maintenance or dirty water: Clean
humidier thoroughly, and ll with fresh water.
White dust is forming on
nearby furniture.
Hard water may deposit dust: Dust in the air
also settles because of added humidity in the
room. Use distilled water if it persists.
Humidifier has stopped
working.
No or low water: Unplug unit and rell tank.
Water is accumulating
outside of unit or area
surrounding unit.
Saturation of humidity: Lower mist control
setting.
Unit not level and water is accumulating:
Unplug and place on level surface.
Point spray away from objects: Raise unit
on a water-resistant level surface 2-3 feet off of
oor.
Water dripping when
relling.
Water remaining on bottom of tank: Wipe tank
or tilt to drain before transporting.
Increased noise level. Unit must be placed on a at, level, hard
surface: Make sure it is NOT placed on a soft or
absorbent surface.
Red light on power dial. Red LED light indicates low water: Unplug
and rell tank.
10 11
Loading ...
Loading ...