Hikvision DS-2TD2117-6/PI User Manual

Loading ...

Safety Instrucon

These instrucons are intended to ensure that user can use the product correctly to avoid danger

or property loss.

Laws and Regulaons

●

In the use of the product, you must be in strict compliance with the electrical safety regulaons

of the naon and region.

Transportaon

●

Keep the device in original or similar packaging while

transporng it.

●

Keep all wrappers

aer unpacking them for future use. In case of any failure occurred, you need

to return the device to the factory with the original wrapper. Transportaon without the original

wrapper may result in damage on the device and the company shall not take any

responsibilies.

●

DO NOT drop the product or subject it to physical shock. Keep the device away from magnec

interference.

Power Supply

●

Check the input voltage before powering on the device to avoid damage.

●

CAUTION: If the fuse of the device can be replaced, replace it only with the same model to

reduce the risk of

re or electric shock.

●

If a fuse is connected to the neutral wire and a double pole/neutral fusing occurs, parts of the

device that remain energized might represent a hazard during servicing

aer operaon of the

fuse.

●

If the device uses a 3-prong power supply plug, it must be connected to an earthed mains

socket-outlet properly.

●

Do not touch the bare components (such as the metal contacts of the inlets) and wait for at least

5 minutes, since electricity may

sll exist aer the device is powered o.

●

For the permanently connected device without a disconnect equipment, a readily accessible

disconnect equipment shall be incorporated into the electrical installaon of the connected

building.

●

For the permanently connected device without an overcurrent

protecon equipment, an

overcurrent

protecon equipment shall be incorporated into the electrical installaon of the

connected building. The specicaons of the overcurrent protecon equipment shall not exceed

that of the building.

●

For the permanently connected device without an all-pole mains switch, an all-pole mains switch

shall be incorporated into the electrical

installaon of the connected building.

●

If the device is powered by terminals connected to the power cord, ensure correct voltage and

wiring of the terminals for connecon to mains supply.

Thermal Network Camera User Manual

Loading ...

Hikvision DS-2TD2117-6/PI Thermal Network Bullet Camera

User Manual - Page 5