Loading ...
Loading ...
Loading ...
5
Installing and Removing Blades
1. Remove battery pack before installing or re-
moving blades.
2. Place the saw on a at surface with the blade fac-
ing upwards. To remove the bolt from the spindle,
push in the spindle lock button. While holding in the
spindle lock button, use the wrench provided with
the tool to turn the bolt counterclockwise. Remove
the bolt and blade ange.
3. Slide the lower guard lever up to raise the lower
guard. Remove the blade from the spindle. Always
clean the spindle, upper guard and lower guard to
remove any dirt and sawdust.
NOTE: Do not remove inner blade ange. Larger
diameter of inner ange should face the blade.
Bolt
Outer ange
Inner ange
Spindle
4. To install a blade, place the blade on the spindle
with the teeth pointing in the same direction as
the arrow on the lower guard. Release the lower
guard lever.
5. Place the blade ange on the spindle and hand
tighten the bolt.
6. While holding in the spindle lock button, use the
wrench to turn the bolt clockwise and tighten.
Adjusting Depth
1. Remove battery pack.
2. To adjust the depth of the cut, hold the saw by the
handle and loosen the depth adjusting lever by
pushing it up towards the motor housing.
3. Raise or lower the shoe to the desired position.
Markings in 1/4" increments are located on the in-
ner side of the upper guard for depth setting. For the
proper depth setting, the blade should extend no
more than 1/8" to 1/4" below the material being cut.
1/4” 6mm
4. Press down on the depth adjusting lever to secure
the shoe position.
Adjusting Bevel Angle
1. Remove battery pack.
2. To adjust the angle of the cut, hold the saw by the
handle and loosen the bevel adjusting knob.
3. Hold the front of the shoe and rotate the saw by
the handle to the desired angle as indicated by
the markings on the bevel scale.
4. Tighten the bevel adjusting knob securely.
Adjusting the Blade to Shoe
The shoe has been adjusted at the factory to a 90
degree setting. Inspect the saw regularly to make
sure the blade is 90 degrees to the shoe.
1. Remove battery pack.
2. Set the bevel pointer to zero.
3. To make sure the blade is 90 degrees to the shoe,
place saw on the blade side and retract lower
guard. Place a square against the blade and shoe
to inspect the degree setting.
Bevel
adjustment
screw
4. To adjust the degree setting, loosen the bevel adjust-
ing knob. Turn the bevel adjustment screw in or out
until the blade is at a 90 degree angle with the shoe.
5. Tighten the bevel adjusting knob securely.
Universal Hose Adaptor
Use the universal hose adapter to
attach the saw to a vacuum hose.
1. Remove the battery pack.
2. Remove the screw and dust
chute from the upper guard.
3. Insert the vacuum hose adap-
tor into the upper guard and
tighten the screw securely.
4. Connect the vacuum hose to
the adapter, twisting together
to secure.
5. To remove, reverse the proce-
dure.
WARNING
Always use either the dust chute
or vacuum hose adaptor/vacuum.
Failure to do so could cause dust or foreign
objects to be thrown into your face or eyes which
could result in possible serious injury.
Loading ...
Loading ...
Loading ...