Loading ...
Loading ...
Loading ...
RESETTING FILTER REPLACEMENT REMINDER
After replacing worn Filter, reset the reminder by using the following method:
1. Locate the small Reset button on top control panel.
2. Press Button using the tip of a pen or paper clip. You will notice 1 LED will begin to flash.
Press the Reset button until the flashing LED is below the Filter you just replaced.
3. Hold the reset button down for 5 seconds to reset reminder. The unit will beep when the
reset is complete.
4. Repeat Steps 1-3 if other Filters were replaced.
REMOTE CONTROL
The Remote Control will work identically to the Air Purifier
except it gives you separate buttons for the UV Germ Shield,
Ionizer, and Auto Functions. The Remote Control will not
reset Filter reminder light. The battery for the Remote, type
CR2032 is already installed. To begin using, pull plastic Tab
on back of the remote.
TO REPLACE BATTERY:
a. Remove the Safety Screw from the Rear Door.
b. Slide the Rear Door up and remove from Remote.
c. Replace CR2032 Battery.
d. Reattach Rear Door and slide down.
e. Align and fasten Safety Screw to Rear Door.
(+)
Battery
Safety Screw
Troubleshooting Guide
My Air Purifier is
constantly changing speeds
The device is running in Auto Mode. In this mode, the Purifier is
always sampling air and adjusting the motor speed accordingly. If
you find this feature disturbing, simply select a fixed speed (H/M/L),
or press the Sleep Mode button.
My Air Purifier is always running
on High Speed when in Auto Mode
For optimum performance, make sure to close the windows and
doors in the room that you are purifying. Outside contaminants, such
as odors and pollen, may continually cause a poor air quality reading.
How do I install the Filters
Please review page 4 for proper Filter sequence. It is important to
install the Filters in the correct order, and routinely replace your
Filters as recommended.
The Air Purifier is running but
I can’t change the settings
a. The buttons detect human touch. If you are pressing the buttons
with a glove or foreign object, the controls may not respond.
b. The Child Lock function may be activated. If the light under
Child Lock button is illuminated, press and hold the button until
you hear a “beep” and the light is extinguished.
The Air Purifier is plugged
in but nothing works
a. If you are using a remote, press the buttons on top of the Air
Purifier. If they work, then the remote’s battery needs to be
replaced. Refer to instructions on Battery Replacement.
b. The Rear Filter Door may have been removed. If so, replace the
Filters and the Filter door.
c. The fused plug is a safety device and may have been activated.
If so, please contact customer service. Do not attempt to replace
or bypass this feature.
HF25630ES
New 4/14
10
ÍNDICE
Advertencias .................................................................................................. 11
Especificaciones del producto ................................................................ 12
Descripción del filtro ................................................................................... 12
Instalación del filtro ..................................................................................... 12
Pautas de operación ................................................................................... 13
Operacion ....................................................................................................... 14
Control remoto ............................................................................................. 15
Solución de problemas .............................................................................. 15
Garantía y Servicio al Cliente ................................................................... 16
New 4/14
7 HF25630ES
Loading ...
Loading ...
Loading ...