Loading ...
Loading ...
Loading ...
![](https://files.manualsfile.com/38690439-aph15e/bga.png)
Airo 10 Electric Panel Heater OIM
DELAY OFF TIMER OPERATION
In addition to temperature controlled operation the heater can also be operated via the use of a delay o timer.
This allows the user to program the heater to operate for a set time period, after which the heater will be returned
back to standby mode.
1. Set the desired operating temperature as per steps 1 through 3 “CONNECTING THE POWER” on page 9.
2. After setting the desired temperature press the MODE button
2
twice. The two digits
5
on the display panel
will now display 0.0 and both the Delay O Set indicator
8
and the H (time) indicator
12
will begin to ash.
NOTE
If after 5 seconds no buttons are pressed the 0.0 display will revert back to the current operating
setting. Simply press the MODE button
2
twice to re-enter the timer setting operation.
3. Press the ‘Up’
3
or ‘Down’
4
buttons to set the required timer operation period.
The delay o timer can be set in 30 minute (
.5) increments up to 9.5 hours and then in 1 hour increments to
a maximum of 24 hours.
4. To exit the delay o timer setting operation either press the MODE button
2
once or wait 5 seconds.
The Delay O Timer Set indicator
8
will illuminate steady to indicate that the heater is now in delay o timer
operation.
If the selected temperature is above that of the current room temperature the red operation indicator
7
will
illuminate and the heater will begin to heat the room.
If the selected temperature is less than that of the current room temperature the red operation indicator
7
will go out and the heater will go into a standby state until the room temperature has fallen below the set
temperature, when the heater will then automatically switch on and heat the room.
The two digits
5
on the display panel will alternate every 5 seconds between displaying the set temperature
and the time remaining of the set delayed o timer period.
5. To cancel delay o timer and return manual operation press ‘Up’ button
3
for 5 seconds.
6. To stop heater operation completely press POWER button
1
, a shutdown falling chime will be heard and the
power indicator
6
will remain illuminated to show that the heater has returned to standby mode.
2
8
4
1
3
7
12
13
B
15
A
5
6
ABOUT YOUR ELECTRIC PANEL HEATER
Loading ...
Loading ...
Loading ...