Loading ...
Loading ...
Loading ...
Video Cable
Video (out)
Monitor
Backup Light Power
Red: + 12V (in)
Black: GND (in)
CAMERA
www.PyleUSA.com
4
REAR VIEW BACKUP CAMERA
Wire Connection
1. Please hard wire the red positive wire connected to the round 1mm DC
plug (pictured below) to your reverse tail light positive 12V connection
and the black wire to the closest available ground. You will probably need
a small length of wire to reach from your reverse tail light to the DC plug.
2. This model is with license plate frame camera, so the unit can be installed
with the number plate.
There is the trajectory parking line function (the camera distance scale line
will be moving according to where the car moves, when car in reverse or
parking status). As the above 2 picture is shown.
3. Please plug the round 1 mm DC plug that you just wired to your reverse
tail light into the red (A) power connection (pictured above)
4. Use the included 5m video cable to connect the yellow video wire (B) to
your video monitor.
Attention:
The camera switch is controlled by the reverse gear shift. When you put your car in
reverse, the camera will receive its 12V power from the reverse tail light.
Loading ...
Loading ...