Loading ...
Loading ...
Loading ...
(4)
ELECTRICAL REQUIREMENTS
Recommended Ground Method
For your personal safety, the hot water dispenser is equipped with a power supply cord
having a 3-prong ground plug. To minimize possible shock hazard, the cord must be
plugged into a mating 3-prong, ground type outlet, grounded in accordance with all local
codes and ordinances.
If a mating outlet is not available, it is the personal responsibility and obligation of the
customer to have a properly ground, 3-prong outlet installed by a qualifi ed electrician.
If codes permit and a separate ground wire is used, it is recommended that a qualifi ed
electrician determine that the ground path is adequate.
A 110 volt, 60Hz, AC only 15 or 20 ampere fused, grounded electrical supply is required. It
is recommended that a separate circuit serving only your hot water dispenser be provided.
Note: Use an outlet that cannot be turned on/off by a switch. If the supply cord is damaged, it must be
replaced by the manufacturer, its service agent or similarly qualifi ed persons in order to avoid a hazard.
INSTALLATION | Before You Begin
IMPORTANT: Make sure that the faucet in compatible to this hot water dispenser. Faucet must be “open vent”
style. Using a standard faucet will damage the tank and void the warranty.
1. Determine where you will install your hot water dispenser. The faucet can be mounted in an existing hole
in the sink, or drill a 1⅜ ”/35mm hole in your sink. Stainless Steel: You need a 1⅜ ”/35mm knockout punch
available at most hardware stores or drill a hole with an expandable drill. Porcelain: Proper tools are required
to drill through a porcelain or cast iron sink. If you are not familiar with this process you should consider having
this done by a professional plumber.
Do not attempt to drill without these special tools as you may severely damage your sink.
2. Make sure you have all necessary parts, tools as suggested on page 2.
3. Determine a convenient location to mount your faucet. This can be existing sink hole in the sink top, or you
may drill another hole into the sink. As you determine the location of your faucet, consider the container you
will use with appliance, such as a large cooking pan. Location of the hole should also provide easy access for
tank connections.
4. The thickness of the sink must be less than 2.7”/70mm.
5. Before connecting to the power source, the dispenser must be fi lled with water and the thermostat turned to
the OFF position.
6. Do not use an extension cord with this appliance. Appliance must be within 36”/914mm of the power source.
7. Plumbing connections must comply with all local codes and ordinances.
8. Do not use any pipe sealing compounds as they may get inside the dispenser causing an objectionable taste
and odor.
9. The suitable water pressure range for this tank is from 35-100psi.
Loading ...
Loading ...
Loading ...