Loading ...
Loading ...
3
enGlIsH
locK seTUP
Follow these steps to get your lock set up and ready to use. If you would like to use a home
automation system to enable remote control of the lock, refer to enrolling on a Z-Wave
network on page 13.
1 Decide what length you want the User codes for the lock to be.
You can set User Codes to be from 4 - 8 digits in length. The default length is 4 digits. All
User Codes must be the same length. Any time you change the User Code length, all current
User Codes will be deleted from the lock.
• See change User code length on page 7.
2 add/Delete User codes.
The lock comes preset with two unique User Codes. You can either use these codes or remove
them and program your own codes.
• See add User code and Delete User code on page 7.
3 Decide if you want to use the auto-lock feature or not. When the
Auto-Lock feature is enabled, the lock will automatically relock itself 30 seconds after being
unlocked.
• See enable/Disable auto-lock on page 7.
4 Turn on the alarm and decide which mode you want to use.
The alarm is turned off by default. If you want to use the alarm, you’ll need to turn it on and
decide on a mode.
• See Programming the alarm on page 8.
Please KeeP THIs GUIDe
This guide contains important information about your lock!
• Default User Codes and Programming Code are located on the sticker on the back of
this guide! You will need these if you ever need to reset your lock back to factory default
settings!
• The sticker also contains your serial number, which may be needed for warranty and
customer service support.
• Instructions for adding and deleting User Codes, changing the lock behavior,
troubleshooting, customer service and more are explained in this guide!
is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including
interference that may cause undesired operation.
Changes or modications not expressly approved by the party
responsible for compliance could void the user’s authority to
operate the equipment.
RF exposure
To comply with FCC/IC RF exposure requirements for mobile
transmitting devices, this transmitter should only be used or
installed at locations where there is at least 20 cm separation
distance between the antenna and all persons.
Under Industry Canada regulations, this radio transmitter may
only operate using an antenna of a type and maximum (or
lesser) gain approved for the transmitter by Industry Canada. To
reduce potential radio interference to other users, the antenna
type and its gain should be so chosen that the equivalent
isotropically radiated power (e.i.r.p.) is not more than that
necessary for successful communication.
This Device complies with Industry Canada License-exempt
RSS standard(s). Operation is subject to the following two
conditions: 1) this device may not cause interference, and 2)
this device must accept any interference, including interference
that may cause undesired operation of the device.
Loading ...
Loading ...
Loading ...