Loading ...
Loading ...
Loading ...
![](https://files.manualsfile.com/28190906-iz420ukt/bg9.png)
17sharkclean.co.uk16 sharkclean.co.uk
MAINTAINING YOUR VACUUM
CLEANING SOFT ROLLER
FLOOR NOZZLE
If any hair is wrapped around the brushroll, continue cleaning using the Carpet setting on a bare floor surface,
a low-pile carpet, or a small area rug� If some fibres remain wrapped around the brushroll after continued use,
carefully remove them� If you run over a hard or sharp object or notice a change in noise while vacuuming,
check the floor nozzle for blockages� (See the Checking for Blockages in the Floor Nozzle section�)
MAINTAINING YOUR VACUUM
CHECKING FOR BLOCKAGES
Checking for Blockages in the Handheld Vacuum:
1. Turn o vacuum�
2. Remove the handheld vacuum from the wand�
3. Check all intake openings on the dust cup and remove
any debris or blockage�
Checking for Blockages in the Wand:
Standard Wand:
1. Turn o vacuum�
2. Remove the handheld
vacuum and floor nozzle�
3. Look through wand to
check for any blockages�
4. Clear away debris and
blockages�
FLEXOLOGY® Wand:
1. Turn o vacuum�
2. Remove the handheld
vacuum and floor nozzle
from the wand�
3. Check the Clog Access
Hose on the FLEXOLOGY®
section of the wand by
pinching the tabs on both
sides of the hose and
lifting the hose out�
4. Clear any debris and
blockages�
Checking for Blockages in the Floor Nozzle:
1. Turn o vacuum�
2. Detach the wand�
3. Use the edge of a coin to open the three locks on the
bottom of the floor nozzle�
4. Remove the cover and tilt back the neck of the floor
nozzle�
5. Check the opening and remove any debris�
6. Replace the cover by sliding the inserts into the slots, then
pressing down firmly on all sides before turning the locks
clockwise to close, until they click securely into place�
1 To remove Soft Roller from nozzle, pull the Soft Roller out
by the tab�
2 Tap loose debris o the Soft Roller� Use a dry towel to wipe
the Soft Roller clean and to remove any debris caught in
the teeth behind the Soft Roller�
3 Hand wash the Soft Roller as needed� Use only water, and let
air-dry completely, which should take at least 24-48 hours�
4 Reinsert Soft Roller until you feel it click into place�
CLEANING THE SENSORS
Make sure to clean the
sensors inside the hand
vacuum regularly, as hair
and other debris may build
up and obstruct them� If
the sensors are partially obstructed, Clean
Sense IQ mode will not adjust suction levels
as expected� If the sensors are completely
obstructed, the F0 error code will appear and
the Clean Sense IQ icon will flash on the hand
vacuum display panel�
To clean the sensors:
1. Turn o power and remove the hand
vacuum�
2. Locate the sensors inside the nozzle of
the hand vacuum� The sensors are on the
interior walls of the nozzle, about 3 inches
down the air path, aligned with the IQ
logos (Fig�2) on the exterior�
3. Gently wipe the sensors with a microfiber
cloth and remove all hair and debris�
4. Turn on power and verify that the unit is
functioning normally�
CLEAN SENSE IQ SENSORS
Hand Vacuum Display Panel
Dust cup
Air path
Fig. 1
Battery
IQ logos-
both sides
Fig. 2
Loading ...
Loading ...
Loading ...