Loading ...
Loading ...
Loading ...
INSTALLING THE STAINLESS STEEL HANDLE
This wine cellar includes a stainless steel handle that is not required to operate this unit. To install the handle
please follow the below instructions:
On the door interior, slightly pull back the
door gasket on the side you wish to install the
handle to reveal the two (2) designated holes
for handle installation.
NOTE: Door gasket must not be removed, detached or
altered as it may directly affect cooling performance.
Using a screwdriver (not included), install the handle tightly
as shown in the diagram above with the included screws,
lock washers and flat washers (2 each).
INSTALLING THE CHARCOAL FILTER
To install the charcoal filter, please follow the below instructions:
Place the carbon filter on top the wooden shelf.
The back of the filter has a 3M glue tape which you can
affix to the shelf or the inside of the unit.
•
•
14
WWW.VIN O T E MP. C O M
INSTALLATION
Remove all packing material before using your wine cooler.
IMPORTANT: Before connecting the unit to a power source, let it stand upright for approximately 24
hours. This will reduce the possibility of a malfunction in the cooling system from handling during
transportation.
Clean the interior surface with lukewarm water and a soft cloth.
This unit is designed for freestanding or built in installation but indoor use only. Position the unit in a dry
and well-ventilated place. Avoid placing the wine cooler near any source of heat or moisture, or in direct
sunlight. Do NOT install the unit in a location with an ambient temperature that will fall below
For built-in installation, leave a
ensure proper air circulation to cool the compressor and condenser. Also, be sure to not obstruct the
front exhaust vent with any objects as this may affect the unit from performing properly.
clearance at the top of the wine cooler are suggested to ensure proper air circulation to cool the
compressor and condenser. Do not place underneath a table, counter top, or anything of the sort as this
will not allow for proper air circulation.
Do not slide the unit into place.
Place the wine cooler on a level surface strong enough to support it when it is fully loaded. T o level the
wine cooler, adjust the front leveling legs at the bottom of the wine cooler.
Plug the wine cooler into an exclusive, properly installed-grounded wall outlet.
Loading ...
Loading ...
Loading ...