Loading ...
Loading ...
Loading ...
Conī®gure Parameters for Access Control Device
Aīer adding the access control device, you can conī®gure its parameters, including overlaying user
informaīon on picture, uploading pictures aīer capturing, saving captured pictures, etc.
Steps
1.
Click Access Control ā Advanced Funcīon ā Device Parameter .
Note
If you can ī®nd Device Parameter in the Advanced Funcīon list, Hover the cursor on the
Advanced Funcīon, and then Click to select the Device Parameter to be displayed.
2.
Select an access device to show its parameters on the right page.
3.
Turn the switch to ON to enable the corresponding funcīons.
Note
ā
The displayed parameters may vary for diī«erent access control devices.
ā
Some of the following parameters are not listed in the Basic Informaīon page, click More to
edit the parameters.
Voice Prompt
If you enable this funcīon, the voice prompt is enabled in the device. You can hear the voice
prompt when operaīng in the device.
Upload Pic. Aīer Linked Capture
Upload the pictures captured by linked camera to the system automaīcally.
Save Pic. Aīer Linked Capture
If you enable this funcīon, you can save the picture captured by linked camera to the device.
Face Recogniīon Mode
Normal Mode
Recognize face via the camera normally.
Deep Mode
The device can recognize a much wider people range than the normal mode. This mode is
applicable to a more complicated environment.
Enable NFC Card
If enable the funcīon, the device can recognize the NFC card. You can present NFC card on
the device.
Enable M1 Card
If enable the funcīon, the device can recognize the M1 card. You can present M1 card on the
device.
Enable EM Card
DS-K1T343 Series Face Recogniīon Terminal User Manual
142
Loading ...
Loading ...
Loading ...