Loading ...
Loading ...
Loading ...
8 Section 2— ASSembly & Set-Up
Securing Control Cable
WARNING: The cable must be routed properly to
avoid contact with all sharp edges and hot surfaces.
Such contacts damage the cable and render the
controls inoperative.
1. Press the stud found inside the snap fitting into the hole
found on the left side of the upper handle, as shown in
Figure 3-3.
Upper
Handle
1
2
Stud
Snap
Fitting
Figure 3-3
2. Push the snap fitting down on the handle to secure it into
place.
Securing Blade Depth Control Cable
Unwrap the blade depth control cable and route it up the right
side of the handle.
1. Pull the depth control lever out of the first position of the
depth control bracket.
2. Push lever all the way forward.
3. Release lever into last position of bracket.
4. Hook the Z end of the depth control cable into the hole on
the depth control lever as shown in Figure 3-4.
1
2
3
4
Figure 3-4
Starter Rope
Locate the rope guide and wing knob found in the manual bag.
Using the wing knob, secure but do not tighten the rope guide to
the right side of the upper handle.
1. Stand behind the edger and hold the blade control against
the upper handle. See Figure 3-5.
1
2
3
4
Figure 3-5
Loading ...
Loading ...
Loading ...