Loading ...
Loading ...
Loading ...
son inscons /
• Indoor Unit
Fnt panel
Terminal (inside)
Connect the power cord to the indoor unit by connecting
the wires to the terminals on the control board individually
in accordance with the outdoor unit connection.
Note: For some models, it is necessary to remove the cabinet to
connect to the indoor unit te『minal.
• Outdoor Unit
1) Remove the access door from the unit by loosening
the screw. Connect the wires to the terminals on the
control board individually as follows.
2) Secure the power cord onto the control
board with cable clamp.
3) Reinstall the access door to the original position
with the screw.
=
Indoor unit
Cabinet
Cha·ssis
Access door
Terminal(inside)
Outdoor unit
4) Use a recognized circuit breakerfor7.1model between
囡Thefigures in this manual are based on the external
;
h
＄尽骂嘉芦言
:
n
e to
l ＄盂骂需芦芦言需芯：它：
selected.
Caution:
1. Never fail to have an individual power circuit specifically for the air conditioner. As for the method of
wiring, refer to the circuit diagram posted on the inside of the access door .
2. Comfirm that the cable thickness is as specified in the power source specification.
3. Check the wires and make sure that they are all tightly fastened aer cable connection.
4. Be sure to install an earth leakage circuit breaker in wet or moist areas.
Cable Specicaons
Capa
cit
y ()
Power cord
Power connecting cord
pe
Normal cross
T
y
pe
Normal cross
-sectional area
-sectional area
2
.5K3.5KW
H07RN-F
1.0 mm
2
X3
H05RN-F
0.75mm
2
X4
5.2KW
H07RN-F
1.5mm
2
X3
H05RN-F
0.75mX4
7.1KW
H07RN-F
2.5mm
2
X3
H05RN-F
0.75mX4
8
.0KW,9.0KW
HO?RN-F
2.5mm
2
X3
H05RN-F
0.75m讨X4
Attention:
T
he plug must be accessible even aer the installation of the appliance in case there is a need to
disconnect it. If not possible, connect appliance to a double-pole switching device with contact
separation of at least 3 mm placed in an accessible position even aer installation.
-29-
Loading ...
Loading ...
Loading ...