Loading ...
Loading ...
Loading ...
CLEANING AND MAINTENANCE - 3391477A548/B
e
4. Two minutes after the Pyrolytic cycle starts,
the indicator light comes on to indicate
that the door is locked by a device that
prevents the door from being opened.
End of Pyrolytic function
At the end, is displayed and flashes
and a beep is activated.
1. Press the touch button on the control
panel to exit the function.
2. Open the door and collect the residue
deposited inside the oven cavity with a
damp microfibre cloth.
It is not possible to select any function once the
door lock device has been activated. It is still
possible to switch off the appliance:
1. Press the button for a few seconds on
the display.
2. When the control panel is reactivated, press
the touch button to end the function.
Programmed pyrolytic function
It is possible to program the Pyrolytic cycle start
time like all other cooking functions.
1. After selecting the Pyrolytic function, press
button.
The indicator light flashes on the display.
2. Press the and touch buttons on
the control panel to set the function end time.
3. Press the button to confirm.
The appliance waits until the set start time to start
the Pyrolytic function.
Extraordinary maintenance
Seal maintenance tips
The seal should be soft and elastic.
• To keep the seal clean, use a non-abrasive
sponge and wash with lukewarm water.
Replacing the internal light bulb
1. Completely remove all accessories from
inside the oven.
2. Remove the rack/tray support frames.
3. Use a tool (e.g. a spoon) to remove the bulb
cover.
It is not possible to select any function
once the door lock device has been
activated. The touch buttons remain
deactivated until the function is
completed.
The door is locked until the temperature
inside the oven cavity returns to a safe
level.
During the Pyrolytic cycle the fans
produce a more intense level of noise
due to a greater rotation speed. This is
an absolutely normal operation,
intended to provide more effective heat
dispersal. At the end of the pyrolytic
cycle, the fans will continue to operate
for long enough to avoid overheating
the walls of adjacent units and the front
of the oven.
During the first Pyrolytic cycle,
unpleasant odours may occur due to
the normal evaporation of oily
manufacturing substances. This is an
absolutely normal phenomenon which
disappears after the first pyrolytic cycle.
If the pyrolytic cycle gives unsatisfactory
results at minimum duration, it is
recommended to set a longer time for
subsequent cleaning cycles.
We recommend wearing rubber gloves
for these operations.
For easier manual cleaning of parts that
are difficult to reach, we recommend
removing the door.
Power voltage
Danger of electrocution
• Unplug the appliance.
• Wear protective gloves.
Loading ...
Loading ...
Loading ...