Loading ...
Loading ...
Loading ...
•
•
•
•
•
•
The MGV550B has a IPX6
The MGV550B should be wired directly to a vehicles battery
When wiring directly to the vehicles battery, be sure to disconnect
the batteries negative terminal wire before starting any wiring
procedures, if extending the main power primary wire, it is
suggested that an optional fuse and fuse holder (not included) with
minimum rating of 15 Amperes be in-line with the positive battery
terminal
The ground cable length should be as short as possible, if
extending from you battery, be sure to use a proper gauge rating for
the length of the run, use only high quality copper primary type wire
weather resistant design, it should not
be submerged in or under water under any circumstances
Do not use abrasive cleaning materials on the lens or bezel
Use only the installation parts provided with the MGV550B
To avoid potential shorts in the electrical
system, be sure to disconnect the (–)
battery cable before installation. Use this
unit with a 12-Volt battery and negative
grounding only. Failure to do so may result
When replacing the fuse, be sure to only use a
avoid short-circuiting, cover any disconnected
leads with insulating tape. It is specially impor
tant to insulate any unused wires, which if left
uncovered may cause a short circuit. When connecting other devices
to this product, refer to the manual for the product to be connected.
Ensure that the ground cable is properly connected to metal parts of
the vehicles body frame or direct to the battery if your vehicle does not
have a grounded chassis frame. The ground cable of this units power
amp and a second powered system must be connected to the frame
separately with different screws. If the screw for the ground wire
The black cable is ground,
Loading ...
Loading ...
Loading ...