Loading ...
Loading ...
Loading ...
䭆
ʺ
UNCRATING & ASSEMBLY
9
9
The PTO shaft turns at a High rate of
speed. If the shaft coupler is not secured
properly at both ends the shaft could fly
loose with enough force to cause serious
injury or death!
DANGER
FIG. 1
FIG. 2
FIG. 3
Tools Required:
Gloves, Tire pressure gauge, Nail bar or claw hammer,
Wire snips, Gloves, Protective eyewear.
Removing the attachment from the crate:
Before disassembling the crate and connecting the two
machines make sure they are both on a level surface.
Using nail bar of claw hammer, remove the top and side
crate panels.
Dispose of top and side panels of the crate.
Remove loose parts and packing material.
Cut any banding, strapping, or chocks that may be
holding the attachment to the crate.
Check tire pressure on all wheels. Refer to
specifications page 11.
This brush mower attachment may be mounted to the
tractor while still on the crate base. Push the attachment
towards the rear of the crate base but do not let it roll off
completely, Chock the wheels to prevent accidental
shifting. Otherwise carefully remove the attachment
from the crate base.
Attaching To Tractor
Disconnect the spark plug wire of the BigMow tractor
and place where it cannot make a connection.
Attach the safety chains to the ROPS and small chain
clips to hold the tractor foot rest up out of the way. (FIG
1)
Engage the hydro bypass lever and push the tractor
behind the attachment. Line up the mounting arms to
the mating connection points on the tractor. Apply a
small amount of Moly EP grease to mounting arms.
Pull out and twist the locking pins on the tractor to hold
the pins open.
Run the winch strap out far enough to connect to the
first strap mounting point (Mowing Mode Strap Mount
Location on page 5). Remove the Ball Lock Pin from the
Mow Height Adjustment Pin Plate if present. (FIG 2)
Connect the deck wire harness to the tractor. DO NOT
START THE TRACTOR!
Push the tractor and attachment together fully engaging
the attachments mounting arms. Rotate the lock pins on
the tractor to release them from the open position. Verify
the pins are fully seated through the mounting arms. If
necessary, the winch strap can be drawn in or otherwise
adjusted to help align the mounting arm angle. (FIG 3)
Connect the PTO shaft to the splined gearbox shaft of
the tractor by sliding back the locking collar on the PTO
coupler and pushing the coupler over the splined
gearbox shaft until the locking collar SNAPS back
completely. Double check the PTO Quick Disconnect is
secure by pulling on the PTO shaft without activating the
quick disconnect collar.
Reconnect the spark plug wire
Read all operating instructions, safety instructions,
and customer responsibilities before operating this
machinery.
Mowing mode
strap location.
Loading ...
Loading ...
Loading ...