Loading ...
Loading ...
Loading ...
GB 10
Description of red indications
Red indication
lights up
Description
Causes
Solutions
“Water tap closed”
Appliance has no or insufficient water supply. The
“Start (Pause)”
light blinks.
Check whether:
•
Water tap is fully open and water supply pressure is sufficient.
•
Kinks are present in the water inlet hose.
•
Mesh filter of water supply hose is blocked (see “Care And Maintenance”.
•
The water hose is frozen up.
•
The safety valve inspection window of your water supply hose is red (provided
your appliance has a water supply hose as shown on picture
“B”
- see previous
chapter “Care And Maintenance”); replace the hose by a new one available
through our After-Sales Service or your specialist dealer.
After problem has been removed, restart programme by pressing
“Start (Pause)”
.
If the fault occurs again, contact our After-Sales Service (see next chapter).
“Clean pump”
Waste water is not pumped out. The appliance stops in the corresponding
programme step; unplug it and check whether:
•
Kinks are present in the drain hose, or the hose is blocked for another reason.
•
Filter or pump is blocked (see chapter “Draining Residual Water/ Cleaning The
Filter”;
make sure the water has cooled before draining the appliance).
•
The drain hose is frozen up.
After problem has been removed, push the “Reset” button for at least 3 seconds;
afterwards restart the desired programme. If the fault occurs again, contact our
After-Sales-Service (see next chapter).
30106320GB.fm Page 10 Tuesday, December 1, 2009 10:47 AM
Black process 45.0° 130.0 LPI
Loading ...
Loading ...
Loading ...