Loading ...
Loading ...
Loading ...
Preventive Maintenance
5:1
Cleaning
A program and/or schedule should be established for periodic inspection, cleaning, and removal of
lint from various areas of the dryer, as well as throughout the ductwork system. The frequency of
cleaning can best be determined from experience at each location. Maximum operating efciency is
dependent upon proper airow. The accumulation of lint can restrict this airow.
• Clean the lint screen after each load.
Weekly
• Clean lint accumulation from lint chamber, and temperature sensor area. See illustration x-x.
• Clean the door gasket.
• Use a soft wash cloth and mild detergent to clean door.
Every Third Month
• Disconnect Power.
• Remove lint from gas valve burner area with a dusting brush or vacuum cleaner attachment.
• Vacuum make up air inlet holes. On removing the lint lter from the lint compartment, clean lint
in the lint compartment.
• Check to clear any accumulated lint around NTC – 1 (See Image below)
• Clean any lint accumulation in and around the motor(s) casing opening.
NOTE: To prevent damage, avoid cleaning and/or touching ignitor/ame-probe assembly located on
the gas burner assembly.
Outlet Thermistor (NTC - 1)
Loading ...
Loading ...
Loading ...