Loading ...
Loading ...
Loading ...
36 www.electrolux.com
Connect the water inlet hose to a tap
with 3/4” BSP thread.
When installing this washing machine,
use the hoses supplied. DO NOT USE
OLD HOSES. The inlet hoses have the
sealing washer fitted.
Tilt the washer a little to adjust the left
front leg.
Never place cardboard, wood or similar
materials under the machine to compen-
sate for any unevenness in the floor.
Install the machine on a flat hard floor.
Make sure that air circulation around the
machine is not impeded by carpets, rugs
etc. Check that the machine does not
touch the wall or cupboard units.
When the washing machine is levelled,
try to rock it from corner to corner. If it
does rock, adjust the legs again until it is
levelled and does not rock.
Turn the taps on and check that there are
no leaks from the connections.
Turn off the water taps and move the
washing machine into its final position.
Make sure that the inlet and drain hoses
do not kink.
Connect the inlet hose to water tab.
Make sure the connections are tight.
Water Tap
Inlet hose
Filter and
rubber washer
inside nut.
You can find a drain hose from inside the
washbowl and a hose clamp from user
manual bag.
Holding the hose clamp and squeezing it
(same as in picture), then put it into the
drain hose inserting side (as shown on
picture).
Insert drain hose into the drainage holes
at the back of the washing machine until
it comes to end, then squeeze the hose
clamp again and shift it to the location as
shown on picture to lock the drain hose.
Squeeze spring hose
clamp
NOTE: Must be ensured that hose is
secured to prevent leak on the floor.
10.3 Water Inlet
10.4 Water Drainage
Loading ...
Loading ...
Loading ...