Loading ...
Loading ...
Loading ...
GAS SPECIFICATIONS AND MOBILE RESTRAINT
Turn down adjustment
• When converting to natural gas the turndown setting will
need to be adjusted to give a satisfactory flame on low
setting on each burner.
• Remove knob from valve shafts. For ignition valve the
low flame adjustment screw is located on the lower right
hand corner of the front of the valve body
Of
• Fully insert and rotate a flat bladed screwdriver to adjust
turndown.
• For non-ignition valves the screw is located inside the
knob spindle. Use a 2.5mm wide flat blade screwdriver
full inserted and make a 3/4 turn counter clockwise.
• After leak testing light one burner and set to high.
• One burner at a time turn the valve shaft to lowest
setting observe the flame to ensure a small steady
flame in achieved.
• Repeat for the other burners.
• Turn off burners and replace control knobs, ensuring the
knob is in the correct orientation when valve is in “OFF”
position.
Secure all joints and leak test
Never use a naked flame to check for gas leaks. The gas
leak testing procedure should be conducted every time a gas
cylinder is refilled and reconnected to the appliance, or after
any new gas connection is made.
In a small container, mix up a solution of water and
detergent or soap. Mix the solution well.
For LPG/propane make sure that the gas supply valve on the
gas cylinder is turned on. For Natural Gas make sure that
the gas shutoff valve is on.
Make sure that the gas control valves on the appliance are all
turned off.
Using a brush or spray bottle apply the solution to the gas
line and each joint in the gas line.
Bubbling of the solution will indicate that there is a leak
present. Re-tighten or re-seal any joints that are leaking.
If a leak persists contact your distributor or the manufacturer
for assistance.
Check proper burner operation
Following operating instructions, light each burner and
check for a clear blue flame with just a tip of yellow. Excess
yellow tipping can be adjusted using the burner adjustment
screw on the side of the burner. Turn the screw in an anti-
clockwise rotation to reduce the yellow.
Yellow
tipping
Yellow
tipping
Right Wrong
Light
blue
Light
blue
Dark
blue
Dark
blue
65INSTALLATION WARNINGS
Loading ...
Loading ...
Loading ...