Loading ...
Loading ...
Loading ...
19
FIG. 42
FIG. 43
FIG. 44
FIG. 45
TT
CC
UU
VV
YY
XX
WW
ADJUSTING 0° AND 45° POSITIVE STOPS
There are built in stops that can position the blade at 0° and
45°. If the blade is not properly at 0° when it is resting on the
stop:
1. Adjust blade to 0° stop and back it off slightly.
2. Loosen the bevel stop nut (UU) slightly using supplied arbor
wrench.
3. Using blade tilting handwheel (CC), position blade at exactly
0°.
4. Use 6 mm hex wrench inside the bevel stop nut (UU)to turn
the stop into place. NOTE: The stop can be rotated either
way to position stop against the trunnion.
5. Hold the stop in place and tighten the bevel stop nut (UU)
with the supplied arbor wrench.
6. Verify position by beveling off and then coming back to the
stop to check blade position.
NOTE: To adjust the 45° stop, use the other bevel stop nut (TT)
and follow the same procedure above.
ADJUSTING BLADE TILT SCALE
Using a combinaton square, turn blade tilting handwheel
until the blade is set perfectly at 45
°. If the blade tilt scale is
not pointing to 45
°, follow these steps:
1. Remove the magnetic cover (VV) Fig. 43.
2. Remove the screw (WW) Fig. 44 using a T20 wrench and
remove the center cap (XX).
3. Loosen angle indicator screw (YY) Fig. 45.
4. Put red pointer on 45
° and tighten screw while holding
the back face so the pointer stays on 45
°.
5. Replace center cap (XX) Fig. 44. Make sure the rubber
O-ring stays seated behind cap.
6. Put magnetic cover (VV) Fig. 43 back on.
Loading ...
Loading ...
Loading ...