Loading ...
Loading ...
Loading ...
Troubleshooting (cont.)
Symptoms Probable Causes Recommended Action
3. Whirlpool stops by itself. A. GFCI or RCD trips. A. Identify source of fault and correct.
If problem persists, refer to
installler/dealer.
B. Suction is blocked. B. Remove obstruction.
C. Jets are blocked. C. Remove blockage.
D. Motor overheated and
protectoin device activated.
D. Check for blockage at motor vents.
Remove bloackage and allow motor
to cool.
Check for suction blockage.
Remove blockage and allow motor
to cool.
Check for jet blockage. Remove
bloackage and allow motor to cool.
4. Noisy operation. A. Pump banding straps have not
been cut. (models with wooden
support blocks only)
A. Cut pump banding straps with tin
snips.
B. Dry or dislodged jet O-ring
(squeal).
B. Remove jet, replace and lubricate
O-ring, and reinstall jet.
5. Heater does not operate. A. No power to heater. A. Set/Reset GFCI or RCD breaker.
B. Water temperature exceeds
104°F (40°C).
B. Allow water to cool; heater will
re-engage.
C. Heater does not work. C. Replace heater. Refer to
installer/dealer.
Kohler Co. 7 1010997-5-H
Loading ...
Loading ...
Loading ...