Loading ...
Loading ...
Loading ...
3
The supplied screw package contains self-tapping
screws, and expansion bolts.
For cement wall/ceiling, expansion bolts are
required to fix the camera. For wooden
wall/ceiling, self-tapping screws are required.
4. Route the cables through the cable hole, or the side
opening.
5. Connect the cables.
6. Check whether the image on the monitor is gotten
from the optimum angle. If not, adjust the camera
according to the figure below to get an optimum
angle.
T
R
Pan Position
[0° to 360°]
Tilt Position
[0° to 90°]
Rotation Position
[0° to 360°]
P
Figure 2-2 3-axis Adjustment
1). Loosen the T adjusting screw to adjust the tilt
position [0° to 90°].
2). Loosen the P adjusting screw to adjust the pan
position [0° to 360°].
3). Loosen the R adjusting screw to adjust the
rotation position [0° to 360°].
7. Tighten screws and the trim ring to finish the
installation.
2.1.2 Ceiling/Wall Mounting with Junction Box
Before you start:
You need to purchase a junction box separately.
Steps:
1. Paste the drill template of the junction box on the
ceiling/wall.
2. Take apart the junction box, and align the screw
holes of the camera with those on the Junction
box’s cover.
3. Attach the camera on the junction box’s cover with
three PM4 × 10 screws.
Figure 2-3 Attach the Camera on the Junction Box’s
Cover
4. Secure the junction box’s body on the ceiling/wall
with three PA4 × 25 screws.
Junction Box
Body
Figure 2-4 Secure the Junction Box on the Wall/Ceiling
Loading ...
Loading ...
Loading ...