MODEL 1PHL25M
OWNER’S MANUAL
OIL-FILLED
RADIATOR HEATER
25" 7-FIN | 1500/900/600W
3
SPECIFICATIONS:
Voltage Rating: 120 V (60Hz) 12.5 Amps
Power Consumption: 1500W
IMPORTANT NOTE:
Read the manual carefully. Make sure to save this manual for
future reference. Illustrations in this manual are for explanatory
purposes only, your actual product may look slightly dierent.
CONTENTS
CONTENTS
SAFETY INFORMATION ........................................................................................... 4
UNPACKING AND SET-UP INSTRUCTIONS ...................................................... 7
OPERATING INSTRUCTION .................................................................................... 7
ADDITIONAL FEATURES ......................................................................................... 9
MAINTENANCE ........................................................................................................... 9
STORAGE ...................................................................................................................... 9
TROUBLESHOOTING ..............................................................................................10
4
SAFETY & PRECAUTIONS
CONTINUEDCONTINUED
SAFETY INFORMATION
IMPORTANT INSTRUCTIONS
When using this electric unit, basic safety precautions should always be followed to
reduce the risk of re, electric shock, and injury to persons, including the following:
1. Read ALL instructions before using this unit.
2. CAUTION: Risk of Electric Shock. DO NOT open or try to repair the heater
yourself.
3. This heater may get hot when in use. To avoid burns, DO NOT let bare skin
touch hot surfaces. If provided, use handle(s) when moving this heater. DO
NOT place it against walls, furniture, curtains, etc.
4. The output of this heater may vary and its temperature may become intense
enough to burn exposed skin. Use of this heater is not recommended for
persons with reduced sensitivity to heat or an inability to react to avoid burns.
5. Keep combustible materials, such as furniture, pillows, bedding, paper,
clothes, and curtains at least 3 ft from the front of the heater and keep them
away from the sides, top, and rear. DO NOT place towels or other objects on
the heater.
6. Extreme caution is necessary when any heater is used. Do not leave invalids
or children unattended with an operating heater. Do not leave heaters
unattended when in use.
7. Always unplug heater when not in use.
8. DO NOT operate any heater with a damaged cord or after the heater
malfunctions, has been dropped, or damaged in any manner. Discard
damaged heater or return heater to authorized service facility for
examination, electrical or mechanical adjustment, or repair.
9. This heater is not intended for use in bathrooms, laundry areas, showers or
swimming pools and similar locations. NEVER locate heater where it may fall
into a bathtub or other water container. To protect against electrical hazards,
DO NOT immerse in water or other liquids.
10. DO NOT touch the control panel or plug with a wet hand.
11. DO NOT run cord under carpeting. DO NOT cover cord with throw rugs,
runners, or similar coverings. Do not route cord under furniture or appliances.
Arrange cord away from trac area and where it will not be tripped over.
12. DO NOT insert or allow foreign objects to enter any ventilation or exhaust
opening as this may cause an electric shock or re or damage the heater.
WARNING
Read and understand this entire owner’s manual, including
all safety information, before plugging in or using this product. Failure to do so
could result in re, electric shock, or serious personal injury.
5
SAFETY INFORMATION
13. To prevent a possible re, DO NOT block the air intakes or exhaust in any
manner. DO NOT use on soft surfaces, like a bed, where openings may
become blocked.
14. A heater has hot and arcing or sparking parts inside. DO NOT use in areas
where gasoline, paint, explosive and/or ammable liquids are used or stored.
Keep unit away from heated surfaces and open ames.
15. To avoid re or shock hazard, plug the unit directly into a 120 V AC electrical
outlet.
16. To prevent overloading a circuit, do not plug the heater into a circuit that
already has other appliances working.
17. It is normal for the plug to feel warm to the touch; however, a loose t
between the AC outlet (receptacle) and plug may cause overheating
and distortion of the plug. Contact a qualied electrician to replace loose
or worn outlet.
18. To disconnect heater, turn controls to OFF, then remove plug from outlet.
Pull rmly on the plug, DO NOT unplug by pulling on the cord.
19. Always unplug the unit before moving or cleaning, or whenever the
heater is not in use.
20. Use only for intended household use as described in this manual.
Any other use not recommended by the manufacturer may cause re,
electric shock, or injury to persons. The use of attachments not
recommended or sold by unauthorized dealers may cause hazards.
21. Always use on a dry, level surface. Use on oor only.
22. DO NOT use outdoors.
23. WARNING: To reduce the risk of re or electric shock, DO NOT use this unit
with any solid-state speed control device.
24. DO NOT attempt to repair or adjust any electrical or mechanical functions on
this unit. Doing so will void your warranty. The inside of the unit contains no
user service able parts.
25. Always use the product in an upright position.
26. This heater cannot achieve accurate temperature control of the environment,
and thus cannot be used as insulation device for storage environment, items,
animals and plants.
27. Use this heater only as described in this manual. Any other use not
recommended by the manufacturer may cause re, electric shock, or injury to
persons.
CAUTION
Always plug heaters directly into a wall outlet.
Never use with an extension cord or power strip.
(Continued)
6
SAFETY & PRECAUTIONS
CONTINUEDCONTINUED
TIP-OVER SAFETY FEATURE
This heater is equipped with a shut-o safety feature. Once the heater is tipped
over, an internal switch will automatically shut the heater o. Once the heater is
restored to an upright position, the heater will reset.
OVERHEAT SAFETY FEATURE
This heater is equipped with an overheat safety feature. When the heater’s
internal components reach a certain temperature that could cause overheating
and possible re, the heater will automatically shut o.
• A thermal overload protector is built in to prevent overheating. When an
“overheat” temperature is reached, the heater will automatically shut o.
Operation can resume only when the user resets the unit.
• To reset the unit, unplug the heater, ensure the power is turned o, and
wait 15 to 20 minutes for the unit to cool down.
• Follow OPERATING INSTRUCTIONS to return heater to operating mode.
WARNING
It is normal for the power cord to feel warm to the touch; however, a loose
t between the outlet and the plug may cause overheating of the plug. If
this occurs, try inserting the plug into a dierent outlet. Contact a qualied
electrician to inspect the original outlet for damage.
SAFETY INFORMATION
(Continued)
7
UNPACKING AND SET-UP INSTRUCTIONS
OPERATING INSTRUCTION
Fig.1
1
2
3
Unpack your heater and nd the wheel
holding plates and buttery nuts between
the n assemblies.
1. Make sure the heater is unplugged
and the power and setting control is
in the “0” OFF position.
2. TURN THE HEATER UPSIDE DOWN.
3. Attach the wheel holding plates onto
the heater as Fig.1 shows. One is
xed between the last two ns and
the other one is xed next to metal
control box.
4. Insert the buttery nuts and tighten
them securely.
5. TURN THE HEATER UPRIGHT.
Your heater is now ready to use.
NO. DESCRIPTION
1 Buttery nuts
2 Wheel holding plate
3 Radiator
CAUTION
Risk of re – Do not operate heater without wheel assemblies
attached. Operate heater in upright position only (wheels on bottom, controls on
top). Any other position could create a hazardous situation.
WARNING
Your heater is equipped with a polarized alternating current line plug (a plug
having one blade wider than the other). This plug will t into the power outlet
only one way. This is a safety feature. If you are unable to insert the plug fully
into the outlet, try reversing the plug. If the plug should still fail to t, contact
your electrician to replace your outlet. DO NOT defeat the safety purpose of
the polarized plug.
8
SAFETY & PRECAUTIONS
CONTINUEDCONTINUED
OPERATING INSTRUCTION
• Place the heater on a rm level surface free from obstructions, and at least
3ft. away from any wall and any other objects such as furniture, curtains,
plants or combustible material.
• With the Power and Setting Control “ 3 ” in the “ OFF ” position,
plug the heater into a grounded 120V outlet.
• Turn the heater “ON” by turning the Power and Setting control “ 3 ”
clock-wise to your desired power setting (LOW, MED, HIGH).
The Power Indicator Light “ 1 ” will illuminate.
• Turn the Thermostat Control “ 2 ” to your desired setting from
“MIN” to “MAX”.
Setting for Optimum Comfort: When the room reaches a comfortable
temperature, slowly turn the Thermostat Control “ 2 ” counter-clockwise until
the heater turns o. This is the point at which the thermostat setting equals
the room temperature. At this setting, the thermostat will automatically turn the
heater on and o to maintain this selected temperature.
NOTE: This heater include a safety tip over switch, which will shut the
heater o in case it is tipped over. If at any time, the heater does tip over,
please put the heater back in the upright position (wheels on bottom,
controls on top). The heater will resume its normal operation.
(Continued)
NO. DESCRIPTION
1 Power Indicator Light
2 Thermostat Control
3 Power and Setting Control
4 Caster Wheels
5 Cord wrap
1
2
3
4
5
9
WARNING
• DO NOT let liquid enter the heater.
• DO NOT use alcohol, gasoline, abrasive powders, furniture polish, or rough
brushes to clean the heater. This may cause damage or deterio ration to the
surface of the heater.
• DO NOT immerse the heater in water.
ADDITIONAL FEATURES
MAINTENANCE
This heater has additional features:
• Cord Wrap
Neatly stores power cord when the heater is not used.
• Convenient Carry Handles
• Heavy-Duty Caster Wheels
Allows for easy maneuvering from room to room.
1. Turn the POWER KNOB to the OFF position.
2. Unplug the unit and let it cool completely.
3. To keep the heater clean, the outer shell may be cleaned with a soft,
damp cloth. Do not use any cleaning agents or detergents.
4. After cleaning, dry the unit with a soft cloth.
5. Wait until the unit is completely dry before use.
STORAGE
Store the heater in a cool, dry location when not in use. To prevent dust and dirt
build-up, use the original packaging to repack the unit.
10
SAFETY & PRECAUTIONS
CONTINUEDCONTINUED
TROUBLESHOOTING
If your heater fails to operate, please follow these instructions:
1. Ensure that your circuit breaker or fuse is working properly.
2. Be sure the heater is plugged in and that the electrical outlet
is working properly.
3. Check for any obstruction. If you nd any obstruction,
turn the heater “OFF”.
4. Unplug the heater and wait a few minutes for it to cool down.
Carefully remove the obstruction. Plug the heater in and turn
it on again by referring to the OPERATING INSTRUCTIONS.
NOTICE: The product is equipped with an overheat safety feature
protector which will switch o the heater in case of accidental over heating
(ex. Obstruction of air intake and outlet grills, motor turning slowly or not at all).
NOTICE: The product is equipped with tip-over switch inside. When
the
product tips over abnormally during its use, it can cut o power automatically.
844-4PA-AIRE | 844-472-2473 | support@perfectaire.us
CANADA SUPPORT 877-997-2473 | supportcanada@perfectaire.us
www.perfectaire.us
5401 Dansher Road
Countryside, IL 60525
Printed in China | 0322_M899
