Loading ...
Loading ...
Loading ...
CHARACTERISTICS
WALL MOUNT Range Hood is designed for designer’s kitchen with the range hood install directly
above cooking appliances against a wall. This hood is a highlight and show piece in your kitchen and
at the same time provide you with the benefit of extracting the grease and smoke from your cooking.
Please refer to the instruction below
INSTALLATION & USE
NOTE: remove protective film (if any) from the exterior surfaces of the hood carefully prior to final
installation.
.DESCRIPTION / CONNECTION
This range hood should be mounted directly to the support frame mounting, where the support frame
flue shall secure to the ceiling joist or framework.
l Ductwork can be installed vertically or horizontally.
l Duct runs should be as short as possible.
l Avoid the use of elbows.
l Use duct tape at all joints.
l Do not use duct smaller than the discharge on the hood.
LOCATION PREPARATION
The installation in this manual is intended for qualified installers, service technicians or persons with
similar qualified background. DO NOT attempt to install this appliance yourself. Injury could result from
installing the unit due to lack of appropriate electrical and technical background.
All electrical wiring must be properly installed, insulated and grounded. Overly accumulated grease in
old duct work should be cleaned out or duct work should be replaced if necessary to avoid the
possibility of a grease fire. Check all joints on duct work to insure proper connection and all joints
should be properly taped.
Note 1 :On stainless steel hoods, carefully remove the plastic protective film from all exterior surfaces
of the hood and chimney prior to final installation.
Note 2 : At least two people will be required to mount the hood.
Loading ...
Loading ...
Loading ...