Loading ...
Loading ...
Loading ...
15
For additional replacement shear pins, please call the customer service department at (800)791 9458.
1. Turn off the machine and wait for all moving parts to come to a complete stop. Remove any
remnants of the broken shear pin. It may be necessary to unscrew the nut from the broken shear pin
and drive out the broken pin.
2. Insert a new shear pin through the hole in the auger shaft and tighten using the shear pin nylon lock
nut. Do not over-tighten the nylon lock nut.
NOTICE: Never replace the shear pins with standard pins or fasteners. Damage may occur to the
snow blower and drive systems.
TROUBLESHOOTING
Problem Cause Solution
The snow thrower does
not start.
The battery is not charged. Charge the battery by following the
procedures in the battery and charger
manual.
The switch is defective Have the switch replaced by an
authorized service center.
Battery is too cold. Remove battery from snow thrower.
Place battery on charger and allow to
charge for 10 minutes. Remove from
charger and install in Snow thrower for
use.
The battery is not attached to
the motor.
Check the connection between the motor
connector and the battery.
Battery may require service or
replacement.
Call toll free helpline, at 1-800-791-9458
or replace battery.
The motor is on, but
the impeller does not
turn.
The belt is damaged. Replace the belt (see the section entitled
Inspecting/Replacing the Drive Belt).
NOTE: Please contact the customer service for any questions.
Loading ...
Loading ...
Loading ...