Loading ...
Loading ...
Loading ...
56-VOLT LITHIUM-ION POWER HEAD—PH1400 15
4. Pull the shaft of the attachment to verify that it is securely locked into the coupler.
If not, rotate the attachment shaft from side to side in the coupler until it snaps
into place.
5. Tighten the wing knob securely.
WARNING:
Be certain that the wing knob is fully tightened before operating
equipment; check it periodically for tightness during use to avoid serious personal
injury.
REMOVING THE ATTACHMENT FROM THE POWER HEAD
1. Stop the motor and remove the battery pack.
2. Loosen the wing knob.
3. Press the shaft-release button and, with the button depressed, pull or twist the
attachment shaft out of the coupler.
MOUNTING AND ADJUSTING THE
FRONT-ASSIST HANDLE
WARNING:
Always remove the
battery pack from the product when you
are assembling parts, making adjustments,
cleaning, or when the product is not in use.
1. Stop the motor and remove the
battery pack, if installed.
2. Loosen the four screws in the front-
assist handle with the supplied hex
wrench and remove the screws and
lower clamp from the front-assist
handle (Fig. 3).
3. Attach the front-assist handle and
lower clamp on the power-head
shaft and secure them by pre-
tightening the four screws. Turn the
front-assist handle upwards so that
it points toward the top of the rear handle (Fig. 4).
3
Lower Clamp
Front-Assist Handle
Screws
4
Coupler
Power-head Shaft
Rear Handle
Housing
Loading ...
Loading ...
Loading ...