Loading ...
Loading ...
Loading ...
15
DUE TO THE SIZE AND WEIGHT OF THIS Range Hood, THE SUPPORT
MUST BE FIRMLY ATTACHED TO THE CEILING. For plaster or sheet
rock ceiling, the support must be attached to the joists. If this is not
possible, a support structure must be built behind the plaster or sheet
rock. The manufacturer assumes no responsibility for injury or damage
caused by improper installations.
WARNING
!
1 1/4"
H
• For all installations, an access point to the hood must be created for
installation and future maintenance of the hood.
• Put a thick, protective covering over cooktop to protect from damage or
dirt.
• Use the mounting template on the ceiling to determine placement of
mounting screws on the ceiling.
• Mark the center of the holes in the ceiling template.
• Determine and make necessary cuts for the ductwork.
• Install ductwork before mounting the hood.
• Determine the proper location for the Power Supply Cable as indicated
on the Template.
• Use a 1 1/4" Drill Bit to make this hole.
• Run the Power Supply Cable. Use caulking to seal around the hole.
• A knockout for threading through the Power Supply from the ceiling is
located on the top of the Range Hood.
• Do not connect the Power Cable to the Wiring Box or power up the hood
at this time.
• Run enough power cable from the ceiling to reach the wiring box on the
hood.
5
Loading ...
Loading ...
Loading ...