Loading ...
Loading ...
Loading ...
ASSEMBLY INSTRUCTIONS
8
STEP 3
Remove the BUMPER(45) from the RAIL(1). Slide the SEAT(54) onto the RAIL(1). Bolt the BUMPER(45)
back to the RAIL(1).
NOTE:
Roller
1. Refer to the inset drawing. If it is di󰀩cult to slide the SEAT(54) onto the RAIL(1), turn the NYLOCK
NUTS(M6)(78) located on both sides of the SEAT CARRIAGE(55) counterclockwise to lower
the position of the Roller.
2. If the SEAT(54) rocks after sliding it onto the RAIL(1), then turn the NYLOCK NUTS(M6)(78)
located on both sides of the SEAT CARRIAGE(55) clockwise to raise the position of the Roller
to tighten it up to the RAIL(1).
Loading ...
Loading ...
Loading ...