Loading ...
Loading ...
Loading ...
6
Container, Lid, Lid Plug and Tamper
• Always use the lid and the lid plug when operating the blender.
• Never operate the blender without checking to make sure that the lid is
securely locked in place.
• The lid plug is marked so it can be used as a measuring cup.
• Ounces, Millilitres and Cups are clearly marked.
• Insert the lid plug through the lid plug opening. Lock the plug in place by
turning clockwise. To remove, turn counter-clockwise and lift out.
• Remove the lid plug to use the tamper or to add ingredients.
• Legacy Vitamix containers (C, G and S Series) will not work on the
Ascent blender base.
64 oz. Container
2-Part Lid
Base
Centering Pad
Tamper
Lid
Lid Plug (in place)
CAUTION
Rotating Blades Can Cause Damage.
Lids and tampers are not interchangeable between dierent container
styles, types and sizes. Use the tamper that was supplied with your
blender.
pa r tS a n d fe at u r e S
WARNING
To Avoid Possible Burns, Never Start on Speeds Above 1 when Processing Hot Liquids in a Large Container.
Escaping steam, splashes or contents may burn. Always start on Variable 1, then slowly increase to 10.
DO NOT use your 20 oz. (0.6 L) cup or 8 oz. (225 ml) bowl to heat ingredients or to blend hot liquids. Heated
ingredients and liquids may create internal pressure which could cause the cup to burst and cause injury.
DO NOT continuously use your machine for more than 75 seconds for the 20 oz. (0.6 L) cup or 8 oz. (225 ml) bowl.
If a cup becomes warm to the touch or steams or vents, immediately stop blending ingredients and turn o or unplug
blender. Allow the cup and ingredients to cool to room temperature before removing the blade base.
Parts will become hot with extended use.
DO NOT touch the drive socket in the blender base or the drive spline in the blade base.
To avoid damage or personal injury, DO NOT use the cups (including the blade base or lids) in the microwave.
WARNING
To Avoid Injury. NEVER TOUCH MOVING PARTS.
Keep hands and utensils out of containers and cups during blender operation. DO NOT insert fingers or
utensils around the blades while the blades are spinning.
The blades will continue to spin until they come to a complete stop at the end of the blend cycle. Allow the blades to
come to a complete stop before handling the blade base and cups.
Put a clean and dry seal onto and then firmly tighten the blade base onto the cup or bowl BEFORE blending.
Do not fill the cup beyond the maximum capacity line or the bowl beyond the 8oz fill line.
If the cup becomes un-threaded from the blade base during operation, turn the machine OFF and wait until the motor
and blades come to a complete stop before attempting to remove the cup and blade base from the motor base.
Loading ...
Loading ...
Loading ...