Loading ...
Loading ...
Loading ...
7
ASSEMBLY INSTRUCTIONS
WARNING
Do not use the device until the blow tube has been properly mounted on the blower housing.
Always switch the tool off before you insert or remove the rechargeable battery.
■ Slightly push the nozzle mouth(10) to the tube (1)until the lockpin(1.1) lock into the hole of the nozzle
mouth, then slide the tube (1) to the main body until with the main body pin(2) lock into the tube.
Note: Occasionally, the permissible temperature range may be exceeded during the charging cycle.
In this case, the electronic charging control interrupts the charging cycle to avoid any damage to the
battery. The read control light will then glow continuously. If you should witness this, pull the battery
from the charging station and let it cool down for about 30 minutes. Then, restart the charging cycle
by sliding the battery back onto the charging station.
■ If you want to remove the rechargeable battery from the tool, press the interlock of the battery
and pull the it from the tool (Fig. 3).
■ To insert the rechargeable battery in the tool, first line up the base of the rechargeable battery with
the guide on the housing (Fig. 4). Then push the rechargeable battery firmly into the tool (Fig. 4)
until hear the locking click into place. If the rechargeable battery is not locked into place, you or other
persons may be injured.
■ Plug the charging device (8) into the mains socket.
Make sure that the mains voltage cited on the charging station complies with the voltage supplied
by your socket. The green light on the right side of the charging station will blink.
■ Slide the rechargeable battery (6) into the charging station. It can only be inserted in one position
(Fig. 5).
■ The battery charging process now begins and is signalled by the red indicator light on the charging
station (9). The 3 green LEDs on battery (6) light up in turn.
■ Once the rechargeable battery has been fully charged, the indicator light on the right side of the
charging station (9) changes to green and red LED extinguish. The charging process ends automatically.
The 3 green LEDs on battery.
■ Charging takes approx. 1-1.2 hours. The battery heats up during the charging process. This is normal
and does not signal a fault. Remove the rechargeable battery after no more than 5 hours.
Installing the blow tube
See Figure 2.
WARNING
Only use the rechargeable battery provided by the manufacturer.
WARNING
Installing and removing the rechargeable battery
Charging the batteries with fast battery charger not included
See Figure 5.
Loading ...
Loading ...