Loading ...
Loading ...
Loading ...
www.PyleUSA.com
9
7. Auxiliary Outputs
The Auxiliary outputs oer PYLE ampliers easy, unlimited system expansion.
Route RCA, from the line out of the rst amplier to the line input of a second
amplier when using a single source output.
8. PHASE: Allows you to invert the subwoofer phase from 0 to 180.
9. SUBSONIC: The frequency can be adjusted between 10Hz and 50Hz.
10. REMOTE
Controls the subwoofer amplier gain from a remote location for ease of
adjustment during listening.
WARNING: Do not connect a lee control knob from other manufacturers to
the Remote sub level control of any amplier. Even though the connectors t
properly, the control knob and connector pin position maybe dierent and
the amplier will be damaged.
11. BLUETOOTH LED Light
When the amplier is successfully connected to the source device,
the (Bluetooth) indicator will stay lit.
12. GND
Connect this terminal directly to the sheet metal chassis of the vehicle using
the shortest wire necessary to make this connection. Always use wire of the
same gauge or larger than the (+) 12 volt power wire. The chassis connection
point should be scraped free of paint and dirt.
Use only quality crimped and/or soldered connectors scraped free of paint
and dirt. Use only quality crimped and/or soldered connectors.
WARNING: Do not connect this terminal directly to the vehicle battery
ground terminal or any other factory ground points.
13. Remote Turn ON
This terminal turns on the amplier when (+) 12 volt is applied to it.
Connect it to the remote turn on lead of the head unit or signal source.
14. (+) 12 Volt Power
Connect this terminal through a FUSE or CIRCUIT BREAKER to the positive
terminal of the vehicle battery or the positive terminal of an isolated audio
system battery.
Loading ...
Loading ...
Loading ...