Loading ...
Loading ...
Loading ...
NOTE: The starting position of the choke will vary depending on the engine temperature. If
starting a cold engine, move the choke lever towards the CHOKE position. If starting a warm
engine, move the choke lever towards the RUN position.
WARNING:WARNING:
Do not try to continuously crank the engine for more than ve seconds at one time. If the
engine fails to start, allow the starter to cool for one minute before trying to restart the
engine. Continuously trying to start the engine will damage the starter.
STARTER DAMAGE
Page 28
Starting the Engine (Dual-cylinder engine)
1. Complete the steps in the OPERATING CHECKLIST section of this manual before
starting the engine. Failure to do so could cause damage to the pump or engine. If
needed, refer to your Engine Owner’s Manual for specic starting instructions.
4. Pull the choke out for starting a COLD engine.
Push in for a warm engine.
3. Slide the throttle to the RUN position (if equipped).
2. Prime the fuel line as described under the CHECKING FUEL section of this manual.
5. Turn the key past the ON position to the START
position. Allow the engine to start. If the engine does
not start after 5 seconds. Release the key and allow
the starter to cool for one minute.
6. Once the engine has started, allow the key to
return to the ON position.
ON
START
The water tank should be lled with water and the spray gun/lance assembly attached
to the high-pressure hose. Place the tank valve in the OPEN position.
Loading ...
Loading ...
Loading ...