Loading ...
Loading ...
Loading ...
UNPACKING
ENVIRONMENT
Most of the packing materials are recyclable. Please
dispose of those materials through your local recycling
depot or by placing them in appropriate collection
containers.
Important – check for any damages or marks. If you find
the refrigerator is damaged or marked, you must report
it within 7 days should you wish to claim for damage/
marks under the manufacturers warranty. This does not
affect your statutory rights.
Clean your refrigerator thoroughly following the
instructions in the “Cleaning” section and wipe off any
dust that has accumulated during shipping.
LOCATING THE REFRIGERATOR
CAUTION
Automatic aerosol systems (such as insect control)
should not be located adjacent to the product as the
spray may cause long term damage to the external
surfaces of the appliance.
Do not put the refrigerator in a location that is too cold
or is unprotected, for example in a garage or on a
veranda. The ambient temperature should be above
10°C.
Put the refrigerator in a dry place avoiding areas of
high moisture or humidity.
Ensure the refrigerator is located on an even surface.
Adequate ventilation around your refrigerator
The diagram below shows the recommended airspace
to allow for ventilation of your refrigerator.
350mm
50mm
Recommended
airspace
CABINET
DOOR
30mm
30mm
X
Y
If you have a cupboard above the refrigerator with a rear
gap of less than 100 mm (Y), recommended clearance at the
top of the refrigerator increases from 30mm to 70mm (X)
minimum.
INSTALLING YOUR NEW APPLIANCE
When positioned in a corner area, spacing of at least
350mm (300mm for EHE5267 model) on the hinge side
will allow the doors to open enough to enable the
removal of bins and shelves.
NOTE: Doors are designed to sit proud of cabinetry (not
flush). The clearances shown above are the
recommended minimum clearances.
The clearance at the rear must not exceed 75mm.
INSTALLING YOUR REFRIGERATOR
300mm
300mm
ETB4607,ETE5407
EBE4507,EBE5307
EBE5367,EFE4227
ERE5047,EBE5007
EBE4302,EBE5002
EHE5267
11
10 - 15mm
Height adjusting nut
Fixed rear rollers
1.Roll the refrigerator into place.
The rollers are designed for forward or backward
movement only. They are not castors. Moving the
refrigerator sideways may damage your floor and
the rollers. Before moving your refrigerator ensure
height adjusting nut and the stability foot are fully
wound up off the floor.
2. Stability foot adjusting nut under door hinge down
until the refrigerator is tilted back by 10mm
(see diagram).
3.Stability
foot adjusting nut on the handle side down
until the refrigerator is level and stable. If you have
difficulty winding the nut or height adjusting foot down
(recommend 20 mm wrench) , have someone tilt the
refrigerator back so you have better access.
stability foot
wound up
Loading ...
Loading ...
Loading ...