Loading ...
Loading ...
Loading ...
4
UNPACKING AND INSTALL THE DOOR HANDLE
Remove the exterior and interior packing materials.
Install the door handle provided with the appliance by following these steps:
Step 1 －Remove the gasket at the inner side of the door
to expose the two screw holes.
Step 2 －Install the handle tightly with the screws
and washers provided.
Step 3 －Tidy and restore the gasket.
INSTALLATION INSTRUCTIONS
Before Using Your Beverage cooler
Remove the exterior and interior packing.
Before connecting the Beverage cooler to the power source, let it stand upright for
approximately 24 hours. This will reduce the possibility of a malfunction in the cooling system
from handling during transportation.
Use a soft cloth to clean the interior surface with lukewarm water.
This appliance is intended to be used in household and similar applications such as
– Staff kitchen areas in shops, offices and other working environments;
– Farm houses and by clients in hotels, motels and other residential type environments;
– Bed and breakfast type environments;
– Catering and similar non-retail applications.
When disposing your appliance, please choose an authorized disposal site.
Installation of Your Beverage cooler
This appliance is designed to be for free standing installation or built-in (fully recessed)
(Refer to sticker location the back of this appliance).
This appliance is intended to be used exclusively for the storage of beverages.
Place your Beverage cooler on a flat floor that is strong enough to support it when it is fully
loaded. To level your Beverage cooler, adjust the front leveling leg at the bottom of the
Beverage cooler.
This appliance is using flammability refrigerant. So never damage the cooling pipework during
the transportation. Locate the Beverage cooler away from direct sunlight and sources of heat
(stove, heater, radiator, etc.). Direct sunlight may affect the acrylic coating and heat sources
may increase electrical consumption. Extreme cold ambient temperatures may also cause the
unit not to perform properly.
Avoid locating the unit in moist areas.
Plug the Beverage cooler into an exclusive, properly installed-grounded wall outlet. Do not cut
or remove the third (ground) prong from the power cord under any circumstances. Any
questions concerning power and/or grounding should be directed toward a certified electrician
or an authorized Products service center.
Attention
Store beverage and wine in sealed bottles;
Do not overload the cabinet;
Do not open the door unless necessary;
Do not cover shelves with aluminum foil or any other shelf material which may prevent air
circulation;
Loading ...
Loading ...
Loading ...