Loading ...
Loading ...
Loading ...
EN - 8
Customization of the quantity
It is possible to customize, for each type of dispensing,
the quantity of coffee or water dispensed
.
• Place a cup or large cup under the
dispenser.
• Press for at least 3 seconds one of the
keys relative to the drink to be dispensed.
The selected key lights up ashing; the
machine emits a double sound to signal
the modication of the preset program.
• On reaching the desired quantity, stop
dispensing by pressing the key again; an
acoustic signal indicates the memorization
of the quantity.
Any customization of the drinks
remains saved for future dispensing.
To restore the manufacturer’s
settings, press the keys
(9)
and
(26) simultaneously for at least 3
seconds.
The machine emits a single sound to
signal the restoration of the factory
settings.
Turning off the machine
• Check that the drip tray (14) is positioned
correctly.
• If there is no water, the machine remains in
the rinse position until the tank is lled.
• Press the button (9), the keys (22), (23),
(24), (25) light up ashing in sequence and
the machine, if it has dispensed at least one
coffee, performs a self-cleaning cycle.
At the end of the self-cleaning cycle, the
machine switches off.
Use
MACHINE SETTINGS
(Fig. B)
Through a programming menu it is possible
to set the water hardness and the acoustic
signals.
Activation / deactivation of acoustic
signals.
The acoustic signals can be disabled /
enabled by keeping the keys (23) and (26)
pressed for three seconds; the key (23) ashes
three times indicating the memorization of the
setting.
Setting the water hardness.
The machine is factory set to “Hard Water
Level”. The machine can also be set according
to the actual water hardness in the various
regions for less frequent descaling.
If you don’t know the water hardness, use
the supplied test strip (21) and follow the
instructions below.
• Remove the supplied reactive strip from its
packaging.
• Fully submerge the strip in a glass of water
for about one second.
• Remove the strip from the water and slightly
shake it. Read the results after about one
minute.
If 5 blue stripes appear on the strip, select
“soft water” settings.
If 1 or 2 pink stripes appear on the strip, select
“average water” settings.
If 3, 4 or 5 pink stripes appear on the strip,
select “hard water” settings.
• To open the water hardness settings,
simultaneously press and hold down keys (22)
and (26) for at least 3 seconds, LEDs (27),
(28), (29) will ash simultaneously.
Loading ...
Loading ...
Loading ...