Loading ...
Loading ...
Loading ...
6
www.linarie.com.au
6. INSTALLATION
7. OPERATION
7.1 First use
This refrigerating appliance is not intended to be used as a built-in appliance.
To fix stably, the appliance must be placed on a flat and solid surface. It should not be laid on any soft material.
Choose a location where there is no heat source. Keep the refrigerator away from direct sunlight or other appliance
producing heat.
Choose a dry and well-ventilated place where there is no corrosive air.
In order to improve efficiency of the cooling system and save energy, it is necessary to maintain good ventilation
around the appliance for the dissipation of heat. For this reason, sufficient clear space should be available around
the refrigerator.
The appliance is supplied with two plastic spacers. After installation of these spacers, the appliance cannot be pushed
agains
t the wall to maintain proper ventilation. Insert the spacers into the relevant openings on the back of the appliance,
then screw the spacers tightly. Place the appliance against a wall with a free distance that not exceeding 75 mm but
more than 50mm.
Before the use of the refrigerator, remove all the packages,
including bottom cushion and foam pads and rubber belts
in the refrigerator.
Adjust the feet and clear the outside and inside of the
refrigerator with warm cloth.
Do not start the refrigerator immediately after vertical
placement. Only start it after 2-6 hours standing to ensure
its proper operation.
To prevent damage to the power cord and any consequence
incidents, the power cord should be not covered by the
refrigerator or other objects. Before switching on the
refrigerator, please check the voltage range of refrigerator
carefully if the same as that of the power supply.
When the refrigerator is first installed, allow it stabilize at
normal operating temperatures for 2-3 hours prior to
fillin
g it with fresh or frozen foods.
If operation is interrupted, wait for 5 minutes before
restarting.
7.2 Testing
7.3 Temperature control
The temperature in the refrigerator compartment and in
the freezer compartment is controlled by the temperature
controller installed on the right side of the refrigerator
compartment.
Turn the thermostat knob to regulate the temperature
inside the refrigerator.
The marks on the knob are not the exact number of the
degrees of temperature but the temperature grades to
“0” from “7”. The first grade corresponds to a forced
STOP of the refrigeration and the 7th grade corresponds
to the lowest temperature the refrigerator can produce.
Turn the knob from "1" position to "7" position, the tem-
perature decreases continuously.
Set the thermostat knob to "3-4"position for a normal use.
Clean the parts of the refrigerator with lukewarm
water on a soft cloth or with a neutral detergent and
with clear water, then wipe them dry.
Notes: Electric parts of the refrigerator can only be
wiped by dry cloth.
Turn the thermostat knob on the "3" position and turn
on electricity. The compressor and the light inside the
refrigerator begin to work.
Close the door and wait 30 minutes. If the temperature
in the freezer compartment decreased obviously, it
shows that the refrigerator system works well. When
the refrigerator operates for a period of time, the
temperature controller will automatically set the
temperature on conditions that the door is not too
often opened.
If the above steps are successful, the trial operations
are finished. The refrigerator works normally.
Note:
The temperature will impact the storage time of food.
Set the temperature as necessary. Warmer will accelerate
food spoilage and colder will frozen food bad.
Thus food to be wasted.
30cm 30cm
50-70cm
Loading ...
Loading ...
Loading ...