Loading ...
Loading ...
Loading ...
CULINARIAN SERIES
38
Verify the type of gas being used at the installation
site matches the gas type of the range. As shipped
from the factory, units are configured for use with
Natural Gas or Propane (LP). Make certain the range
matches the type of gas available at the location.
For installation of the appliance at high altitude,
please consult your local gas company for their
recommendation of the correct orifice sizes and any
other necessary adjustments that will provide proper
gas combustion at specified altitudes.
The Anti
-
Tip Bracket may be attached to a solid
woodcabinethavingaminimumwallthicknessof3/4".
STEP 4: INSTALLING ANTI
-
TIP DEVICE
For all Ranges, an anti
-
tip device MUST be installed
as per these instructions.
Failure to follow these instructions may result
in electrical shock or other personal injury.
CAUTION: PROPERTY DAMAGE!
Contact a qualified installer or contractor to
determine the proper method for drilling holes
through the wall or floor material (such as ceramic
tile, hardwood, marble, etc.)
DO NOT slide range across unprotected floor.
Failure to follow these instructions may result
in damage to wall or floor coverings.
WARNING!
ALL RANGES CAN TIP
INJURY TO PERSONS COULD RESULT
INSTALL ANTI
-
TIP DEVICES PACKED WITH
RANGE
SEE INSTALLATION INSTRUCTION
WARNING: RANGE TIPPING HAZARD!
All ranges can tip and injury can result. To
prevent
accidental tipping of the range, attach
it to the floor, wall or cabinet by installing the
Anti
-
Tip Device supplied.
A risk of tip
-
over may exist if the appliance is
not
installed in accordance with these instruc-
tions.
If the range is pulled away from the wall for
cleaning, service or any other reason, ensure
that
the Anti
-
Tip Device is properly re
-
engaged
when
the range is pushed back against the
wall. In
the event of abnormal usage (such as
a person standing, sitting, or leaning on an
open door);
failure to take this precaution can
result in tipping
of the range. Personal injury
might result from spilled hot liquids or from the
range itself.
WARNING: ELECTRICAL SHOCK HAZARD!
Use extreme caution when drilling holes into
the
wall or floor. There may be concealed
electrical
wires located behind the wall or
under
the floor.
Identify the electrical circuits that couldbeaffected
by the installation of the Anti
-
Tip Device, then
turn
off power to these circuits.
The thickness of the wall or floor may require use of
longerscrews, availableatyourlocal hardwarestore.
In all cases at least one (1) of the bracket mounting
screws must be fastened to solid wood or metal
on each side.
Use appropriate anchors when fastening the
mount-
ing bracket to any material other than hardwood or
metal.
MOUNTING ANTI
-
TIP BRACKET:
IMPORTANT INSTALLATION INFOR-
1.
Screwdriver, Phillips
2.
Drill, electric or hand
3.
Measuring tape or ruler
4.
1/8" drill bit (wood or metal wall or floor)
5.
3/16" anchors, drywall, or concrete, 2 each (not
required if mounting bracket is being attached to
solid wood or metal.
6.
Hammer
TOOLS NEEDED FOR INSTALLATION
OF ANTI
-
TIP DEVICE!
NOTE: Capital DOES NOT supply ranges to match
varying altitudes. Orifices toadjust for combustion
for
differing altitudes may be purchased through
Capi-
tal Cooking Equipment by calling our Parts
De-
partment at 1
-
866
-
4024600, or email us at cus-
tomerservice@capital
-
cooking.com.
PlacebracketonfloorinpositionshowninFigurebelow.
Secure to floor or wall stud.
Later, when unit is installed, the adjustable leg will
slide
under the bracket
The alternative floor mounted bracket shall
be
installed
as follows:
STEP 5: GAS CONNECTION AND HOOK
-
UP
INSTALLATION INSTTRUCTIONS
Loading ...
Loading ...
Loading ...